Safety Instructions

Power
The Power button switches the ZVOX speaker between off (STANDBY)
and on. When the ZVOX AV120 is powered on, you will see a white light
follwed by a green light behind the front speaker grille ash. When it is
powered off into STANDBY, you will see the red light ash four times. Any
button press from the ZVOX remote will also power on the system.
Note: The ZVOX AV120 will also enter STANDBY if it receives no audio
signal for several minutes.
Button Functions on the ZVOX Remote Control
BACK
MUTE
PLAY/PAUSE
OTHER
SETTINGS
VOLUME
ACCUVOICE SURROUND
FWD
INPUT
POWER
Volume
When the volume up arrow button is quickly pressed and released,
you will see the light corresponding to your input (Green, Blue, Red)
ash indicating one volume step increase. If you press and hold down
the volume up button, the light will continuously ash and the volume
will go up until you release the button. The volume down arrow button
is indicated by the yellow light and ashes in the same manner when
pressed and released.
Mute Play/Pause
Press this button to mute the ZVOX speaker. When the MUTE function
is active, the display blinks yellow repeatedly. The AV120 will enter
STANDBY if it is left in MUTE for longer than 5 minutes. The button also
doubles as the Play/Pause function when using sound bar with the USB
Drive and/or the Bluetooth
AccuVoice
Press the AccuVoice button to select the AccuVoice function. Additional
presses of the AccuVoice button allow you to select increasing
levels of voice enhancement. There are two levels of increasing voice
enhancement, starting with AccuVoice 1 going to 2. The light ashes
purple a certain number of times to indicate which AccuVoice mode you
are selecting. The default setting is AccuVoice 1. If you were to press
the AccuVoice button once you would see the light blink twice indicat-
ing AccuVoice 2 mode. Once you are in AccuVoice 2 mode, pressing
the AccuVoice button will return you to AccuVoice 1.
Back and Forward
The Back and Forward buttons will allow you skip forward, or back,
from audio tracks when using the USB Drive Input or Bluetooth
connections.
Other Settings
The OTHER SETTINGS button can be used to control the Auto on/off
feature when the minijack input is selected OR to cancel a bluetooth
connection and start the pairing process when the Bluetooth input is
selected.
Input Selection
Press the INPUT button on the ZVOX remote to select between
the speaker’s input modes. Note: The USB input is not selectable
unless a USB thumb drive is plugged in.
Surround Settings
There are two SURROUND levels: Surround One has low virtual surround
effect and strong vocals. Use this setting if vocal clarity is important to you.
Surround Two has moderate virtual surround effect and moderate vocals.
The default setting is Surround 1. If you were to press this button again you
would see the Pale Blue light blink twice indicating Surround 2 mode.
4 ZVOX AV455 | Remote Control