Other Content

ManualsBrandsZVOX ManualsElectronicsZVOX SoundBase 770 42” Sound Bar With AccuVoice Hearing Aid Technology, 3 Built-In Powered Subwoofers

The PS Menu

The SoundBase has a variety of function

and sound adjustments that could prove

useful depending on the SoundBase

owner’s installation and usage preference.

The list of adjustments is called the

PS Menu.

If your TV set does not have a “internal

speakers off” feature or if your TV displays

a distracting “TV speakers off” message,

the PS menu allows you to adjust the

SoundBase and your preferred remote

control so that the volume buttons on your

preferred remote control adjust the sound

just from the SoundBase and not the TV.

These adjustments are made using the four

front panel buttons on a SoundBase while

watching the LED display. The SoundBase

remote control cannot make adjustments to

the PS Menu.

MUTE VOLUME INPUT

Press both buttons for three or

more seconds to trigger the PS

number adjustment mode.

(866) 367-9869 | info@zvoxaudio.com

Adjusting the PS Menu

To make a selection from the PS menu listing,

press and hold down both the MUTE and

VOLUME UP front panel buttons for about 3

seconds. If this is the rst time you have used

the PS menu, you will see the characters

“PS-0” start ashing. Immediately release the

two buttons when you see the PS number

ashing. Then quickly press and release

the Volume Up button while “PS” is still

ashing. This will increase PS number setting.

Pressing Volume Down will decrease the PS

number setting, down to “PS-0”. Each time

you press the Volume Up or Volume Down

button, you have an additional six seconds to

make an adjustment.

Once you arrive at your intended PS number,

just wait for the display to stop ashing the

PS number. When the ashing stops, the

adjustment is made.

This guide applies to the SoundBase models 350, 450, 570, 670, 770 and 870.

It does not apply to the SoundBase 220, 320, 420, 555 and 580

and earlier ZVOX Audio products.

While ashing, the Volume Up or Down

buttons set the PS number. After adjustment,

the setting is stored when the display turns off.

ZVOX SoundBase

Adjustment Options

Summary of content (4 pages)

PAGE 1
ZVOX SoundBase Adjustment Options ® This guide applies to the SoundBase models 350, 450, 570, 670, 770 and 870. It does not apply to the SoundBase 220, 320, 420, 555 and 580 and earlier ZVOX Audio products. The PS Menu Adjusting the PS Menu The SoundBase has a variety of function and sound adjustments that could prove useful depending on the SoundBase owner’s installation and usage preference. The list of adjustments is called the PS Menu.
PAGE 2
PS Emulation Modes The first six options in the PS menu are emulation modes. See “Using the SoundBase remote control emulation modes” for instructions. No brand Sony emulation LG Samsung Vizio Panasonic Marantz There are no PS number choices between PS 6 and PS10.
PAGE 3
Using the SoundBase remote control emulation modes PS 1 through PS 6: Most SoundBase users teach the SoundBase to respond to their preferred remote control using the SounBase built-in “learning” function. Should this approach not work with your preferred remote control, there is an alternate method that can allow your preferred remote to control the sound level heard from the SoundBase.
PAGE 4
Master Reset A master reset restores a SoundBase to the factory default behavior. It erases any “learned” remote control response. It sets the SURROUND mode to Surround “2”, sets OUTPUT LEVELING and DIALOG EMPHASIS to OFF and sets BASS and TREBLE to no boost or cut in bass or treble output. It sets the INPUT to Optical Input 1. To perform the Master Reset, first put the SoundBase in Standby mode by pressing the POWER button on the SoundBase remote control.