901ZT Quick Start Guide 1
LEGAL INFORMATION Copyright © 2019 ZTE CORPORATION. All rights reserved. No part of this publication may be quoted, reproduced, translated or used in any form or by any means, electronic or mechanical, including photocopying and microfilm, without the prior written permission of ZTE Corporation. Notice ZTE Corporation reserves the right to make modifications on print errors or update specifications in this guide without prior notice. We offer self-service for our smart terminal device users.
Version No.: R1.
Getting to Know Your Phone Indicator light Front camera Proximity & light sensor Earpiece nano-SIM/ microSDXC card tray Volume key Power key Touch screen Main microphone Speaker Headset jack Dual-lens camera Flash Fingerprint sensor Charging/USB Type-C™ jack 4
Installing the nano-SIM Card and the microSDXC™ Card (Optional) The nano-SIM card can be installed or removed while the phone is turned on. WARNING! To avoid damage to the phone, do not use any other kind of SIM cards, or any non-standard nano-SIM card cut from a SIM card. You can get a standard nano-SIM card from your service provider. 1. Insert the tip of the tray eject tool into the hole on the card tray. 2.
or cause the battery to explode. WARNING! Do not remove the back cover. The battery is not removable. Removal may cause fire or explosion. 1. Connect the adapter to the charging jack. 2. Connect the charger to a standard AC power outlet. 3. Disconnect the charger when the battery is fully charged. NOTE: If the battery is extremely low, you may be unable to power on the phone even when it is being charged. In this case, try again after charging the phone for at least 10 minutes.
Product Safety Information Don’t make or receive phone calls while driving. Never text while driving. Keep your phone at least 5 mm away from your body while making calls. Small parts may cause choking. Your phone can produce a loud sound. To prevent possible hearing damage, do not listen at high volume levels for long periods. Exercise caution when holding your phone near your ear while the loudspeaker is in use. Avoid contact with anything magnetic.
For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily accessible. Don’t rely on your phone as a primary device for emergency communications. CE Caution Battery Caution Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. USB Port This product shall only be connected to a USB interface of version USB 2.0. Proper Use As described in this guide, your device can be used only in right location.
Disposal of Your Old Appliance 1. When this crossed-out wheeled bin symbol is attached to a product, it means the product is covered by the European Directive 2012/19/EU. 2. All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities. 3. The correct disposal of your old appliance will help prevent potential negative consequences for the environment and human health.
EU DECLARATION OF CONFORMITY Hereby, ZTE Corporation declares that the radio equipment type 901ZT is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet address: http://certification.ztedevices.com FCC Regulations This device complies with part 15 of the FCC Rules.
-Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. Specific Absorption Rate (SAR) information: This wireless phone meets the government's requirements for exposure to radio waves.
emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value.