Owner’s Manual ZT ZT Amplifiers Club Guitar Amplifier CLG1
Features Top Panel REVERB 7 TREBLE 6 BASS 5 GAIN VOLUME 4 INPUT 3 2 1 Rear Panel 9 EFX OUT IN 10 / Line Volume Speaker Out 8Ω Minimum C LUB Guitar Amplifier CLG1 11 8 17 / Line Out Voltage 115 12 Speaker Internal External On 16 Power Off Fuse T2AL 250V 15 14 ~115V/230V 60HZ/50HZ 200W Aux Input 13
Top Panel Features 1. INPUT Jack –– Plug in your instrument here. The input can take a wide range of instrument signal levels based on how you set the gain control. 2. GAIN Control –– Controls the amount of input signal to the amplifier. Turn this up for a soft overdrive. 3. VOLUME Control –– Controls the master volume of the amplifier. 4. BASS Control –– Turn all the way to the right for extra warmth, or all the way to the left to roll off the lows and increase clarity.
Important Safety Instructions READ INSTRUCTIONS – All safety and operating instructions should be read before the appliance is operated. RETAIN INSTRUCTIONS – Safety and operating instructions should be retained for future reference. HEED WARNINGS – All Warnings on the appliance and in operating instructions should be adhered to. FOLLOW INSTRUCTIONS – All operating and use instructions should be followed.
SAFETY CHECK – Upon completion of any service or repairs to this product, ensure the service technician has performed safety checks to determine that the product is in proper operating condition. HEARING LOSS – Sustained high sound pressure levels can cause temporary or permanent hearing damage. HEAT AND SUNLIGHT – Avoid lengthy exposure to high heat or direct sunlight to prevent damage to the vinyl finish.
Troubleshooting In talking to our customers, we’ve found that most issues can be resolved with a few simple checks. If you’re having a problem with your amplifier, try running through the following steps.
Limited Warranty ZT Amplifiers, Inc., warrants that the ZT product you have purchased shall be free of defects in part LIMITED WARRANTY. TO TRANSFER THE WARRANTY TO A SUBSEQUENT PURCHASER, YOU MUST ENDORSE THE SALE OF THE PRODUCT TO THE SUBSEQUENT PURCHASER ON THE FRONT OF THE SALES RECEIPT. THIS LIMITED WARRANTY IS VOID WITHOUT SUCH ENDORSED SALES RECEIPT.