User's Manual

ManualsBrandsZoom Telephonics ManualsElectronicsFCC CFR Title 47 Part 15 Subpart C Part



1103WLUserGuide





 



User Guide

Single‐Band 802.11n Half mini‐PCIe Wireless LAN Card

Summary of content (7 pages)

PAGE 2
1103WL User Guide Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 3
1103WL User Guide This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna. 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.
PAGE 4
1103WL User Guide Antenna List No. Manufacturer Part No. Antenna Type Peak Gain 1 ARISTOTLE REF‐02‐P118‐70B‐150 Dipole Antenna 4.2 dBi for 2.4 GHz 2 KINSUN 2AN‐C101WE‐019R Dipole Antenna 2.28 dBi for 2.4 GHz 3 KINSUN 2AN‐C101WE‐029R Dipole Antenna 1.76 dBi for 2.4 GHz 4 KINSUN 2AN‐C101WE‐049R Dipole Antenna 2.24 dBi for 2.4 GHz 5 KINSUN 2AN‐C201BK‐019R Dipole Antenna 1.97 dBi for 2.4 GHz 6 KINSUN 2AN‐CA01WE‐019R Dipole Antenna 1.76 dBi for 2.
PAGE 5
1103WL User Guide 1. INTRODUCTION The 1103WL provides ultra-high performance (up to 150 Mbps) transmission rate in the 2.4GHz band. Backward compatible with the current 802.11 b/g/n network devices gives your laptop the freedom of wireless connectivity with the performance, security, and manageability industry standards in the security and quality of service (QoS), as the draft 802.11i and 802.11e standards respectively.
PAGE 6
1103WL User Guide 2. INSTALLATION 2.1 Installed in Laptop PC The Mainboard of the system should provide a Host connector and Cable connection for wifi module. Please follow the SOP to install & assemble it step by step. 2.2 Testing in Lab The module is embedded inside Notebook or other Equipment. If for testing purpose, we provide the “Testing Board” in order to let tester connect 1103WL via the special cable connection to PC externally. The Testing Board provides 3.3V conversion from PC Host.