Introduction Zonar Systems Hardware Installation Tips For Professional Installers Zonar Systems equipment will provide years of reliable service if properly installed and maintained. Zonar equipment is typically installed in heavy vehicle applications and is often subject to extreme temperatures, dust, dirt, vibration, and shock. Proper installation is the critical first step to equipment longevity and optimal performance.
Table of Contents Introduction ……………………………………………………………i Warranty & Notices …………………………………..………………2 General Guidelines ……………………………………………..……3 Schematic ....................................................................................4 ZPassTM Mounting ……………………………………………………5 Cables …………………………………..…………………………….6 TM © 2008 Zonar Systems Inc. • EVIR, ZPass are trademarks of Zonar Systems Inc. TM , zAlert , and Ground Traffic Control All Rights Reserved.
Warranty & Notices Limited Warranty Zonar® will provide customer with a replacement for nonconforming hardware or software within a commercially reasonable time after timely notice from customer. Zonar does not represent or warrant that the hardware and software are free of bugs or errors and shall not be liable for any losses (financial or nonfinancial) occurring as a result of such bugs or errors.
General Guidelines Layout Cable Management 1) 13) Strain relief and support all cable installations. 14) Avoid sharp bends and tight radius installations of cables. 15) Avoid moving components. (e.g. doors, steering, shafts, handles, fans, etc.) 16) Provide an adequate “Service Loops” i.e “cable slack” to allow for servicing of equipment. 17) Avoid routing cables thru doors, windows, and other pinch points. 18) Avoid routing cables in high personnel traffic areas.
Schematic
ZPassTM Mounting The Mounting System: 1) 2) TM Holds the ZPass Reader Is generally mounted near passenger entrance/exit Note: Verify placement acceptability with state DOT/Law Enforcement prior to installation. 3) TM Ensure location of installed ZPass does not block driver view and interfere with vehicle operation and loading/unloading of passengers (e.g. snag coats, book bags, etc.
Cables ZPassTM Power Cable 1) Follow all General Guidelines as specified on page 4. 2) All power leads (Red and White leads, GPS-Power Cable) must be connected to the vehicles protected circuitry (e.g. fuse panel, circuit breaker panel, protected circuits). Never electrically connect Zonar equipment to unprotected circuits. (e.g.