FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation Information to the User This equipment has been tested and found to comply with the limits for a class B digital device pursuant to part 15 of FCC Rules.
TOL #85 Introduction Before You Start Electron-static Discharge st SD) Safety Precautions Necessary Equipment Installation Steps ooo Selecting the Com Part Jumper stings Recommended Jumper stings Connecting fou sound card (optional .. Connecting to 3 sound card (via CD-ROM audits-in) [& netting 10 a sound card (via Sound cards Inserting the Installing Telephone Lines... 2 .
INTERNAL FAX/MODEM INSTALLATION 1 Introduction Congratulations on your purchase. The Bellatrix Cobra uses Rockwell's state-of-the-art HSF chip set. Host-controlled modem software performs processing of general modem control, command sets, fax Class 1, speakerphone, voice/audio/TAM, error correction, data compression, and operating system interface functions. 1.1 Before You Start If you've never installed an add-in board in your computer before, please follow the instructions in this section carefully.
& EEE. Chapter 1 Internal Fax/Modem Installation 1.3 Installation Steps The steps to install your modem are shown in order in this section. For some steps, you may need to refer to your computer's User's Manual. 1.3.1 Selecting the COM Port ‘The Bellatrix Cobra is PnP and can use COM ports 1 10 8 and IQ's 2,3,4,5,10,11,12 & 15. This is selected automatically. There are no hardware jumpers or dip switches to set. Refer to Chapter 2 for the Windows software installation instructions.
13 +» HEINE WERE Chapter 1 Internal Fax/Modem Installation Installation Steps The steps to install your modem are shown in order in this section. For some steps, you may need to refer to your computer’s User's Manual. 13.1 The Selecting the COM Port Bellatrix Cobra is PnP and can use COM ports 1 to 8 and IRAs 2,3,4,5,10,11,12 & 15. This is selected automatically. There are no hardware jumpers or dip switches to set. Refer to Chapter 2 for the Windows software installation instructions.
| i MAN-SPEECHES 4 917198, 12:29 PM Ml » EEE Chapter I Internal Fax/Modem Installation 1.3.3 Recommended Jumper settings Following are the recommended settings for various uses: i Passive speakers {non amplified) Use the factory default settings. 2. Active speakers (amplified) Shortstop, Penelope, IP4=2&3 3. Sound card connection Opening, Penelope, JP4=2&3 4. Headset Shortstop, Opening, IP4 1.3.
6. Press the board firmly into the slot ensuring that the gold tabs on the fax/modem are aligned with the connectors in the slot. 7 Insert the screw and tighten slightly. Check to ensure that the telephone, Jacks in the back of the modem arc unobstructed. If so, then tighten the screw securely. 8. Replace the computer cover. 1.3.8 Installing Telephone Lines The Fax/Modem has two modular telephone jacks on the back of the modem.