User's Manual

SA-H0017 一氧化碳报警器 快操 REV-A00
尺寸：75*90mm（成品尺寸）
材质:105g双铜+双面印刷4C +折页
Pivot
Quick Start Guide
3
4
5
2. Support
Having difficulty?
For more instructions, troubleshooting, support, and
other resources, please visit:
www.zmodo.com/support
Like us on Facebook.com/Zmodo
Scan the QR-code!
Follow us on Twitter @Zmodo
Scan the QR-code!
3. Connect with us!
REV-A00
1 2
Quick Start Guide
Gas Detector
The Zmodo Smart Accessories Kit provides a full solution to
monitor your home. All devices can be connected and
controlled through the Zmodo app. The following describes
the main features of this system.
1.Connect your Gas Detector
Gas Detector: When paired with a Beam, the gas
detector alerts you with audible warning sounds and
a phone notification when gas is detected.
Find a suitable location to install the gas detector, and follow
the instructions for installation.
Water and alcohol exposure may decrease the sensitivity of
the sensor and cause false alerts.
Do not place in highly corrosive environments.
Avoid pollution from alkali, alkali salt, and halogens.
Do not expose to volatile silicon compound vapors or high
concentrations of gas, which can cause significant damage
to the equipment.
①
②
③
Freezing may cause significant damage to the detector.
Warning:
Find a suitable location to install the gas detector. Plug the
gas detector into a nearby power outlet. When you first plug
it in, the status light will blink green, then red and the alarm
will sound. Afterward, it will blink green (initializing) and
eventually solid green (standby). You can pair the detector
in either the initializing or standby phase.
In order to connect the gas detector, access your Beam's
Device Settings and select the "Accessories" option. Select
the Add Accessory option, follow the on-screen +
instructions, and push the button on the gas detector when
prompted to pair it with your Beam.
When gas is detected, the light will blink red, the alarm will
sound, and you will receive a notification on your phone.
You can deactivate the alarm by pressing the
button on the gas detector.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.