User's Manual

Pivot
Quick Start Guide
3
4
2. Support
Having difficulty?
For more instructions, troubleshooting, support, and
other resources, please visit:
www.zmodo.com/support
Like us on Facebook.com/Zmodo
Scan the QR-code!
Follow us on Twitter @Zmodo
Scan the QR-code!
3. Connect with us!
REV-A00
1 2
Quick Start Guide
Beacon
The Zmodo Smart Accessories Kit provides a full solution to
monitor your home. All devices can be connected and
controlled through the Zmodo app. The following describes
the main features of this system.
1. Connect your Beacon
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Remove the plastic tab to power on the Beacon. In order to
connect your Beacon, access your Beam’s Device Settings
and select the "Accessories" option. Select the icon to add
+
an accessory, follow the on-screen instructions, and when
prompted, push the Beacon to pair it with your Beam.
Note: In order to replace the battery (CR2032), you can open the
Beacon by inserting a screwdriver into the slot where the plastic tab
was originally located and carefully prying it open.
Beacon: When paired with a Beam, the beacon sends an alert
for help to paired smart devices and phones.
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions (1)this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Model: SA-H0016