Door / Window Sensors Quick Start Guide
1 Getting to know your Sensors 2 Mobile Setup This quick start guide will help you configure your door / window sensors. Take Pivot as an example, the sensors is configured in the Pivot settings menu. 1 After your Pivot is successfully configured, tap the “Setting” menu on the right upper corner of the interface. 2 Select the “Accessories” menu in the middle of the screen, and tap it. 3 Press the Add Device option (+) to add the sensors.
4 Press the button of the larger sensor on one side. 5 Name your Sensors and set a password for it if you need. Tap √ to complete the setup. 3 Installing your Sensors 1 Remove the plastic tab on the bracket. 2 Install the larger sensor on the door or window frame, and the smaller sensor on the moveable part of the door or window. When closed, the maximum distance between the two sensors should be 2cm.
Scan the QR-code below Follow us on Twitter @Zmodo Scan the QR-code below 6 Import Information This equipment has been tested and found to comply with the limits for a Class B digital device, p ursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection a gainst harmful interference in a residential installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.