R angetops Installation Guide and Users Manual
REGISTERING YOUR PRODUCT ZLINE Kitchen and Bath provides Attainable Luxury, where the kitchen and bath of your Please register your ZLINE appliance. Begin the simple registration process by dreams is never out of reach. Through our unique designs and unparalleled quality, we’re scanning the QR code. dedicated to providing you an elevated experience in the heart of your home. With an endless selection of features and finishes, our inspiration is your reality.
WARRANTY WARRANTY COVERAGE WHAT IS NOT COVERED ZLINE Kitchen and Bath range products will be warrantied for one year from the 1. original purchase date for the original purchaser of the product. This warranty covers all parts and labor for necessary repairs if any part of the product proves to be Installation or start-up, damages or problems caused by improper installation or use. 2. defective in materials or workmanship.
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS 1 An air curtain or other overhead range/cooktop hood which operates by WARRANTY AND SERVICE 3 WARNING blowing downward airflow onto the range, shall not be used/installed in conjunction with this gas range.
SAFETY INSTRUCTIONS WARRANTY AND SERVICE • A manual gas shut-off valve must be installed in the gas supply line ahead of the Please keep this manual for future use. oven in the gas flow for safety and ease of service. The rating tag shows the model and serial number of your range. The tag is located on the underside of the product. Do not remove permanently affixed labels, warnings, or plates from the product. This will void the warranty.
BEFORE INSTALLATION BEFORE INSTALLATION SIZES INSTALLATION ADJACENT TO KITCHEN CABINETS 27 27"7/16(695) ” 23"15/16(608) 23 ” 22"3/4 ” (70) For the best look, the worktop should be level with the cabinet countertop. 7/ 16 30“ 15/ 16 /8 ” 47"7/847 (1215) 7 3/ 4 8“ 27.5“ 36“ 27.5“ 48“ 11"5/16 ” (33.5) 5/ 16 7 ” 7/ 8 1"3/8 (35) 18“3/8” 5"3/8 (137 53/8” 1"15/15 (48.5) 2” 8“ 27.
INSTALLATION INSTALLATION A properly grounded and horizontally-mounted electrical receptacle type NEMA 14- • This appliance shall only be installed by an authorized professional. 50R should be installed no higher than 3” above the floor, no less than 2” and not • The appliance shall be installed in accordance with the standards of the country more than 8” from the left side (facing product); refer to electrical connection section. where it will be installed.
INSTALLATION INSTALLATION ROOM VENTILATION • All gas connections must comply with national and local codes. The gas supply An exhaust fan may be used with the appliance; in each case it shall be installed line (service) must be the same size or greater than the inlet line of the appliance. in conformity with the appropriate national and local standards. Exhaust hood This range uses a ½˝ NPT inlet.
INSTALLATION INSTALLATION MANUAL SHUT-OFF VALVE PRESSURE REGULATOR This valve is not shipped with the appliance and must be provided by the installer.
INSTALLATION INSTALLATION GAS CONVERSION PROCEDURE STEP 1: PRESSURE REGULATOR The gas conversion procedure for this range includes: The pressure regulator supplied with the appliance is a convertible type pressure 1. Pressure Regulator regulator for use with Natural Gas at a nominal outlet pressure of 4˝ w.c. or LP gas 2. Surface Burners at a nominal outlet pressure of 11” w.c. and it is pre-assembled from the factory 3.
INSTALLATION INSTALLATION STEP 2: SURFACE BURNERS STEP 3: FLAME ADJUSTMENT To replace the nozzles of the surface burners, lift up the burners and unscrew the 1. Light one burner at a time and set it to the MINIMUM position (small flame). nozzles shipped with the range using a 7 mm (socket wrench). 2. Remove the knob. 3. The range is equipped with a safety valve. Using a small-size flathead Replace nozzles using the conversion set supplied with the range.
INSTALLATION OPERATION INSTALLATION CHECKLIST ROOM VENTILATION 1. Is the back guard securely connected? The use of a gas cooking appliance generates heat and humidity in the room where 2. Is the electricity properly grounded? it is installed. Proper ventilation in the room is needed. Make sure the kitchen is 3. Is the gas service line connected following the directions of the manufacturer? equipped with a range hood of appropriate power (400 CFM minimum). Activate 4.
OPERATION OPERATION SURFACE BURNER OPERATION - ELECTRIC IGNITION Be sure to set all worktop/oven/broiler burner controls to the OFF position after each To activate the electric ignition, simply push the knob in to activate the spark. While use of the appliance. still pushing the knob in, turn the control knob counter-clockwise to release the gas. OFF The spark will be released at the metal tip of the white ceramic pin located on the side of the burner.
MAINTENANCE AND CLEANING TROUBLESHOOTING CLEANING YOUR RANGE PROBLEM POSSIBLE CAUSE During cleaning operation, never move the appliance from its original WARNING Rangetop is not connected to electrical power. installation position. Never use abrasive cleaners! Scratches on the stainless Check power circuit breaker, wiring, and fuses. If Igniters are not sparking steel surfaces are permanent. Do NOT clean the range when hot! all electrical components are properly installed, call customer support.
Installation Guide and User Manual 2.0.0 1-614-777-5004 contact@zlinekitchen.com www.zlinekitchen.
