Quick Start Guide UHF 6Pro Series Reader Version: 1.
1. Product Summary UHF 6Pro series is a new generation of RFID UHF series product of our company's independent research and development of the long distance card reader system for parking lots. The product adapts Impinj R2000 card reader chip, and the card reader part adapts module integrated design. It has stable card reading performance, good card reading performance consistency, long service span, minimized external interference, and the product adapts waterproof casing design.
1) In "Trigger Read" work mode, the reader will not read cards before a low level signal to "Trigger Point" is delivered. "Trigger Point" is mainly used for working with the ground sensor of vehicle parking system. 2) In "Always Read" work mode, once the card is in the effective range, the reader will output the card number via Wiegand continually. 3. Technical Parameter Working Voltage DC9V ~ 12V Working Current 1.
1) USB Connection 2) Software Introduction Our company provides Demo, used to set the working parameters of the reader.
Work Mode Read Always Communication Interface Wiegand26 Output Power Working Frequency 33dBm UHF 6E Pro: 865MHz ~ 868MHz; UHF 6F Pro: 920MHz ~925MHz Demo Using Instructions Connect the USB port of the reader to the USB port of the computer. It is recommended to use power adapter with DC12V/3A specifications. To play Demo in computer, click “Connect”, on the right side of the middle will show “Successfully Connected”. Wiegand Output Time: Sets the time interval between adjacent wiegand data.
. Access Control Panels Connection UHF Reader 7. Installation Please install the directional antenna with lower elevation angle of 60~75 to suit the correct line of sight. NOTE: Please install the reader as shown in the above picture. The reader is facing the direction and the direction of travel of the vehicle is in a straight line. The distance between the reading head and the parking barrier is maintained at 50cm or more.
Avoid installing the reader against to another. The position of the tag/card in the vehicle is as follows: The reader detection distance may vary depending on rain, snow or wind. The Reader should be away from strong magnetic field when working.
ZK Building, Wuhe Road, Gangtou, Bantian, Buji Town, Longgang District, Shenzhen China 518129 Tel: +86 755-89602345 Fax: +86 755-89602394 www.zkteco.com 7 © Copyright 2014. ZKTeco Inc. ZKTeco Logo is a registered trademark of ZKTeco or a related company. All other product and company names mentioned are used for.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.