Installation Instructions
WALL LEDGE
STEP 4
Hang shelf.
STEP 3
Tighten screws into anchor(s) and the stud(s).
Maximum load claim
SHELF: HOLDS UP TO 8 lbs (3.6 kgs)
1/8"
(3mm)
STEP 2
2a
Drywall mounting: Tighten the anchors into
dry wall with Philips screw driver until anchors
are flush with the wall surface.
STEP 1
1a
Drywall mounting: Choose a desired location.
Mark mounting holes for anchors.
1b
Stud mounting: Choose a desired
location. Use a stud finer and mark
the location of studs.
2b
Stud mounting: Drill pilot hole and drive
the stud screw into the pilot hole.
TOOLS NEEDED (Not included in product)
Pencil
Screwdriver
Level
Stud Finder
Drill
NOTE FOR STUD MOUNTING:
◆
Anchor is not necessary for stud mounting.
◆
Additional tool/hardware may be required
for stud mounting, or if on wall surfaces
other than dry wall. Consult your local
hardware store.
HARDWARE (Included in product)
plastic dry wall anchor
Size : 9mm
Ø x 32mm L
philip head screws
mounting bracket
Stud screw (6mm Ø x 30mm L)
Anchor screw (6mm Ø x 25mm L)
If shelf cannot hang on to the screws, untighten the screws slightly and re-hang.
Repeat as necessary.