Installation Instructions

Using tin snips,
cut out a 45
degree angled
section of the
downspout
extension.
Slide the cut section of
the downspout
extension into the Zip
Hinge and secure with
zip screws. Make sure
the down-spout is fully
seated before attaching.
*Zip screw is not included.
Slide the Zip Hinge
onto the elbow of the
down-spout and
secure with zip screws.
Make sure the Zip
Hinge is fully seated
before attaching.
45˚Cut
1
4 Zip
Screws
2
4 Zip
Screws
3
Zip On, Flip Up
Bend clasp at
notches to
approximately
20 degrees.
Rotate clasp to
vertical position
to hold extension
upright.
Use zip screw or 1/8”
rivet to attach clasp
3/4 inches above
raised extension.
*Zip screw is not included.
PO Box 940, Elkhorn, NE 68022
[phone]
www.ziphinge.com
ALWAYS WEAR
SAFETY GLASSES
INSTALLS IN
1 MINUTE
12
6
39
ALWAYS WEAR
SAFETY GLOVES
20˚ Bend
20˚
Notch
20˚
1
Notch
1 Zip
Screw
2
Rotate
Clasp to
Vertical
3
Optional Zip Hinge™ Clasp
Installation Instructions
TOOLS REQUIRED: 1 Zip Screw, 1/4” Hex
Bit, Drill or 1/8” Rivet and Rivet Gun
Zip Hinge™
Installation Instructions
TOOLS REQUIRED: Tin Snips, 8 Zip
Screws, 1/4” Hex Bit and a Drill