User's Manual

Uniwave UniTransport System Setup

User Manual

Zinwave recommends that the DL IP power presented to the Downstream PH is set to -25dBm. Also

set the UL AGC Threshold to a little higher than this, -20dBm is recommended.

The settings are calculated when you click Validate Settings, and applied to the hardware when you

then click the Apply Settings button. Expect the calculated uplink gain to be higher than the downlink

gain, even when Uplink/Downlink balance is set to 0dB – this is correct, the overall system gain is

balanced, but the gain split between the upstream and downstream hubs is deliberately not the same

in UL and DL directions.

12.3 Configuration of Downstream Primary Hub

Any Primary Hubs connected to a UniTransport Hub are described as downstream of the UniTransport

Hub. They will have Transport Modules fitted to their Service input slots. These Transport Modules

need to have the same RF input power level assigned to them as the output Transport Modules that

feed them in the UniTransport hub. Zinwave recommends that you set the Calculated Input Level

to -25dBm.