User's Manual

Uniwave Initial System Setup

User Manual

To install a new software release:

The software release ‘.dat’ file must be accessible to the system hosting the Web browser being used

to access the Configuration GUI. Go to the Software Upgrade page.

Select New Software Release

Click the 'Choose File…' button to select a full new Software Release to be uploaded to the system.

The software version details will be displayed.

Software File Transfer

Specify whether software auto-installation (involving reboot of affected units) should be automatically

performed after software file transfers are completed or not, by selecting one of the options from the

drop-down list “Auto-Install after transferring”:

• No the “Install” button or “Cancel” button are available at the end of the transfer.

• Yes, asap following upload The firmware is installed onto the Primary Hub and flashed onto

every Remote Unit and Secondary Hub automatically. The system reboots.

• Yes, by scheduler The installation and reboot process can be scheduled on the System

Maintenance page, so the down-time can be arranged at a convenient moment out-of-hours.

Click the “Start” button to Upload and Decompress the software image files to all the Primary Hub,

Secondary Hubs and Remote Units. This is carried out in a serial manner, and firmware transfers may

take up to 4 hours in a large DAS. The firmware image will only be transferred to SHs and RUs that

require updating. A progress bar will indicate the status of each Hub and Remote Unit transfer.

Software / Firmware Installation

Once all required Hub and Remote Unit transfers have reached 100%, software / firmware installation

will proceed according to the “Auto-install after transferring” setting. The “Install” button will be made

available and can be selected to initiate the software installation process manually.