User's Manual

Uniwave Understanding the Configuration GUI

User Manual

9.3 Accessing the GUI

The GUI is initially accessible via a Web browser through a secure (https) connection (but can be

changed to an unsecured (http) connection via the “User Interface Settings” section of the Hub Setup

page.) For initial configuration of a device, you need local access via an ethernet connection to the front

of the Primary Hub. After that, you can access the Hubs and Remote Units remotely on the network

you created during the initial setup.

To access the GUI:

1. Open the desired browser.

2. In the address line, enter “https://ip_address” where the IP address is the address of the

Primary Hub you wish to configure. For an initial configuration the IP address is

https://192.168.0.2. If you changed it in the “IP Settings” section of the Hub Setup page, use

that address.

3. Press Enter.

4. A Security Certificate authorization may appear depending on whether the PC you are using

to access the device has previously been used. If it appears, continue to step 5. If not, and

the Login window appears. Go to step 7.

5. Accept the Security Certificate.

6. Depending on your browser, a series of acceptances may need to be confirmed. Click

through the options to accept the Certificate. You may need to select advanced options to

see all acceptance options.

7. The Login window appears (browser specific.)

8. Enter the username and password. There are three privilege levels available.