User's Manual

ManualsBrandsZhuhai Xingyu Model Products ManualsElectronicsRadio Control System

T4-2400 Transmitter operation Introduction

1. Electronic Specification

a. Operation frequency: 2402- 2480MHz, total 79 frequencies (the space of close

frequencies is 1 MHz)

b. FHSS transmitter mode

c. Output power≤4Mw

d. Channel: 4 proportional

e. Operation voltage: 4.8V

f. Operation current＜25mA

2. Using Guide

a. Power on the transmitter, the voltage of the battery no less than 4.8V, all the 3 LED s

(from left to right: red, yellow and green) illuminated; when the voltage of the battery

between 4.4V-4V, green light off; when the voltage below 4V, just the red light on, and

then we must charge the battery with the included charger. Please review the attached

circuit diagram of the charger.

b. As the diagram 1 shown, the top transmitter case has 2 control sticks, and their

performance as following:

Left stick,

Up and down, control the Throttle

Left and right, control the Rudder

Right stick,

UP and down, control the Elevator

Left and Right, control the Rudder

There are 4 trim levers near the 2 sticks, respectively trim the throttle, rudder, elevator

and aileron throw.

Summary of content (3 pages)

PAGE 1
T4-2400 Transmitter operation Introduction 1. Electronic Specification a. Operation frequency: 2402- 2480MHz, total 79 frequencies (the space of close frequencies is 1 MHz) b. FHSS transmitter mode c. Output power≤4Mw d. Channel: 4 proportional e. Operation voltage: 4.8V f. Operation current＜25mA 2. Using Guide a. Power on the transmitter, the voltage of the battery no less than 4.8V, all the 3 LED s (from left to right: red, yellow and green) illuminated; when the voltage of the battery between 4.
PAGE 2
c. There are 4 switches on the right bottom of the top case of the transmitter, respectively for aileron, elevator, throttle and rudder reverse switches. d. In the left corner, there is a trainer switch, when the 2 transmitters connected by a trainer core with the trainer jack at the back of the transmitter; stir the trainer switch can make the two transmitters have the trainer function. e. f. As the diagram 2 shown, it the back sight diagrams of the transmitter, the charger jack on the left side.
PAGE 3
FCC NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment.