Document No.: TSS-iAdapterL2_FU-001 Version No.: V1.0 IADAPTERL-2_FU TRANSMISSION ADAPTOR USER MANUAL Total 5 Pages Formulated by: Mo Yiting Audited by: Yang Shaohua Reviewed by: Xu Yinhua Countersigned by: Ma Jinhui Approved by: Li Baofu Zhuhai Unitech Power Technology Co., Ltd. Sept.
Modification Records Date 2011.9.7 Version V1.
Contents i. ii. iii. iv. v. vi. vii. Introduction .............................................................................................................................. 3 Appearance ............................................................................................................................. 3 Instructions for Indicator Lamp ............................................................................................. 5 Instructions for Buzzer .........................................
i. Introduction The iAdapterL-2_FU adaptor is used in conjunctions with “UT2000IV operation order expert system” or “JOYO-J centralized control system” , which can be communicated with the host computer via USB and serial ports, the iAdapterL-2_FU adaptor doesn’t require any configuration in communication via USB and serial port, but the Zigbee module needs to be configured under the UT-NET communication mode.
Back: Install the antenna into the antenna input port as blow figure. Turn the antenna to the vertically upward direction.
iii. Instructions for Indicator Lamp (1)Power Indicator Lamp: When power is normal, the green light is normally on. (2)Charging Status of Charging Indicator Off The green light is normally on. Status of Adaptor/Smart key No smart key is detected by the adaptor. The adaptor detects that the smart key is properly placed and the charging loop is normal. The red light is normally on. The smart key is improperly placed and the charging loop is abnormal.
iv. Instructions for Buzzer Buzzer Indication Beep The charging state changes or normal prompt tone during the communication process; Beep… Beep… Beep… Failure or communication error occurs during charging process. v. Instructions for Operation (1) Charge Put the smart key in charging position when it is powered on. Then the adaptor will charge the smart key automatically. The charging process will be indicated on the screen of the smart key.
vi. Technical Parameters Outline Dimensions: 336×176.6×149.2mm Input Current: Alternating Current 85~265VAC Direct Current 110~330VDC Charging Voltage: 5V Charging Current: 400mA Static Working Current: ≤200mA Working Temperature: 0℃~45℃ Relative Humidity: 30%~95% Environment Infrared Resistance Strength: No Less Than 0.
Radio Frequency Magnetic Field Conduction Immunity: Grade 3 (10V/m) Power Frequency Magnetic Field Immunity: Grade 5 (100A/m) Pulsed Magnetic Field Immunity: Grade 5 (100A/m) vii. Warning FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This equipment should be installed and operated with minimum distance 20cm between the radiator& your body.