Application Manual

Zhuhai Jinhong Technology Co.,Ltd V1.0-2021

ETHERNET AIR application manual

Appearance:

Remarks：

A： Power input 5~12Vdc; B: Network port; C: Power indicator;

D: Receive/transmit indicator; E: Signal strength indicator； F：Antenna;

Application guide:

1. Connect the antenna to the SMA antenna connector.

2. When the power adapter is connected to the DC port and power on,the five

indicator lights will flash for 3 seconds to enter the self-test.When the power light and RX

light are always on,the devices is the receiving device;if the RX light is not on，the device

is the transmitting device.

3. Connect video monitoring:RX device is connected with NVR or computer through

network cable,and TX device is connected with IPC camera through network cable to

realize remote video monitoring.

4. WIFI coverage expansion:the TX device is connected to the LAN port of the router

through the network cable,and the RX device is connected to the WAN port of the router

through the network cable to realize remote WIFI coverage.

PAGE 1
ETHERNET AIR application manual Appearance: F A B Remarks： A： Power input 5~12Vdc; D: Receive/transmit indicator; C D E B: Network port; C: Power indicator; E: Signal strength indicator； F：Antenna; Application guide: 1. Connect the antenna to the SMA antenna connector. 2. When the power adapter is connected to the DC port and power on,the five indicator lights will flash for 3 seconds to enter the self-test.
PAGE 2
5. FCC Statement 6. 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 7. (1) This device may not cause harmful interference. 8. (2) This device must accept any interference received, including interference that may cause undesired operation. 9. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 10. NOTE: 11.