User's Manual

Operation

1. Put the detector at place where you want, within the flood sensor detection range

when where is leaking all over the place, and both the two probes detect water at the

same time, the sensor will be triggered and send signal to your receiver.

2. Normal operation, the LED will not light.

3. If the cover of sensor is removed, the tamper switch will send signal according the

Status/Signal table, and the LED will go flash once.

Federal Communications Commission Statement

This equipment has been followed to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try and

correct the interferene by one of the following measures:

- Reorient or relocate the receiving antenna,

- Increase the separation between the equipment and receiver,

- Connect the equipment into and outlet on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undersired

operation.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate this equipment.

Limited Warranty

OPLINK Guarantees that every flood sensor is free from physical defects in material and

workmanship under normal use for one year from the date of purchase. If the product

proves defective during this one-year warranty period, OPLINK will replace it free of

charge. OPLINK does not issue any refunds. This warranty is extended to the original end

user purchase only and is not transferable. This warranty does not apply to : (1) damage

to units caused by accident, dropping or abuse in handling, or any negligent use; (2) units

which have been subject to unauthorized repair, taken apart, or otherwise modified; (3)

units not used in accordance with instruction; (4) damages exceeding the cost of the

product; (5) transit damage, initial installation costs, removal cost, or reinstallation cost.

For information on addional devices, plesae visit us at www.oplink.com

-3-

Installation & Operation Manual

WLS1300

Water Leak Sensor

(Flood Sensor)

PAGE 1
Operation 1. 2. 3. Put the detector at place where you want, within the flood sensor detection range when where is leaking all over the place, and both the two probes detect water at the same time, the sensor will be triggered and send signal to your receiver. Normal operation, the LED will not light. If the cover of sensor is removed, the tamper switch will send signal according the Status/Signal table, and the LED will go flash once.
PAGE 2
Installation Introduction Thanks for choosing the OPLINK flood sensor of the home security device. This sensor sends signal when it detects water. We can put it under the refrigerator, and the sensor will triggered when the refrigerator leaking and both the two probes of detector detect water at the same time. You can also set the detector at anywhere leaks; with this sensor you can avoid loss before the calamity and the flood.