User's Manual

Oplink Communications

User Guide

I. Product Introduction

Shock sensor is a 433MHz wireless remote control. When the monitor device

shock exceed 1 G, and it will send arm/disarm/panic signal to the system.

Stand by

Montor device

Was strongly

impact

Vibration strength

more than trigger

threshold

Transmit RF

singal

Receiver

PAGE 1
Oplink Communications User Guide I. Product Introduction Shock sensor is a 433MHz wireless remote control. When the monitor device shock exceed 1 G, and it will send arm/disarm/panic signal to the system.
PAGE 2
Oplink Communications II. Installation (1) Usage scenario: • Indoors or windows and away from direct sunlight. • Away from extreme temperature sources and large metal objects. (2) Operation： • push the locker of Remote control.
PAGE 3
Oplink Communications FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PAGE 4
Oplink Communications Europe – EU Declaration of Conformity This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test methods have been applied in order to prove presumption of conformity with the essential requirements of the R&TTE Directive 1999/5/EC: - EN 60950-1: 2006+A11:2009+A1:2010+A12:2011 - EN 300 220-1 V2. .1 (201 -0 ) - EN 300 220-2 V2. .1 (201 -0 ) - EN 301 489-1 V1.9.2 (2011-09) - EN 301 489-3 V1.4.