User's Manual

ManualsBrandsZhongshan Symbol E-Commerce ManualsElectronicsRemote control

Table Of Contents

页 2

Controller User Manual

DC Fan Lamp Remote

Fan Reverse

Press this Key when the fan works

Natural Wind

Speed 1 to speed 6 cycle switching

Switch Indicator

Speed Controller

Fan Shutdown

Lamp Switch

Timer

Once pressing the timer key, please

do not press any other keys. Or the

order will be cancelled.

Tips:

The remote control has been paired before leaving the factory and it can be used directly after installation.

Re-pairing is required when you need to add or replace a new remote.

110-240V

Motor W

For Light N

For Light L

Motor V

Motor U

Live Wire L

Neutral Wire N

AC100-260V

50Hz

Wiring Diagram of Receiver

White Wire

Blue Wire

Gray Wire

Red Wire

Yellow Wire

Live Wire L

Neutral Wire N

Please turn off the power supply before installation

You will hear a “beep” sounds when the receiver powered on. And then, please press the “Light ON/OFF” key immediately

till you hear a long “beep” sounds. It means success.

VOLTAGE

45W

FAN

300W

LAMP

300W

LAMP

Function Introduction

Matching Method

Notices

1.When the emitter is unable to remotely control the receiver, please check whether the switch batteries are in good contact,

whether they are fixed properly and whether they run out of use.

2.When the emitter is unable to remotely control the receiver, please check whether there is other remote control products

around the space and check whether the keys are pressed down, because same nature of remote control product may cause

interference with each other resulting in poor receiving effect. Taking away such articles will normalize the remote

control function.(the infrared remote controller is not included).

3.Please use this product under applicable voltage. Too low voltage will lead to failure of the remote controller to work

(Please refer to the product label for the voltage range and related parameters).

4. Please take out the batteries if you will not use this product for a long time.

Summary of content (2 pages)

PAGE 1
DC Fan Lamp Remote Controller User Manual Function Introduction Switch Indicator Speed Controller Fan Shutdown Fan Reverse Press this Key when the fan works Natural Wind Speed 1 to speed 6 cycle switching Lamp Switch Timer Once pressing the timer key, please do not press any other keys. Or the order will be cancelled. Matching Method You will hear a “beep” sounds when the receiver powered on. And then, please press the “Light ON/OFF” key immediately till you hear a long “beep” sounds. It means success.
PAGE 2
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.