Installation Instructions

ManualsBrandsZhongshan Shesheng Electronics ManualsElectronicsBluetooth module

I2C address:

Thus, a write command is a A8 and a read command is a A9.

I2C commands:

Read:

Command: Data

36 = BT pairing mode 00 = not paired yet

36 = BT pairing mode 55 = successfully paired

06 = flags bit 0 = 0 normal = 1 in pairing mode

Bit 1 = 0 not connect to host = 1 connected to host

Bit 2 =

Write:

63 = exit pairing mode 00 = NA

4A = set to volume level xx = volume level ( put in range of volume levels we can use)

55 = go into BT pairing mode 00 = NA

84 = go to low power mode (standby or low current mode) 00 = NA

87 = come out of low power mode (default mode when turned on)

Summary of content (5 pages)

PAGE 1
I2C address: 54 Thus, a write command is a A8 and a read command is a A9.
PAGE 2
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 3
Requirement per KDB996369 D03 2.2 List of applicable FCC rules List the FCC rules that are applicable to the modular transmitter. These are the rules that specifically establish the bands of operation, the power, spurious emissions, and operating fundamental frequencies. DO NOT list compliance to unintentional-radiator rules (Part 15 Subpart B) since that is not a condition of a module grant that is extended to a host manufacturer. See also Section 2.
PAGE 4
2.5 Trace antenna designs For a modular transmitter with trace antenna designs, see the guidance in Question 11 of KDB Publication 996369 D02 FAQ – Modules for Micro-Strip Antennas and traces. The integration information shall include for the TCB review the integration instructions for the following aspects: layout of trace design, parts list (BOM), antenna, connectors, and isolation requirements. a) Information that includes permitted variances (e.g.
PAGE 5
For situations where the host product manufacturer is responsible for an external connector, for example with an RF pin and antenna trace design, the integration instructions shall inform the installer that unique antenna connector must be used on the Part 15 authorized transmitters used in the host product. The module manufacturers shall provide a list of acceptable unique connectors. Explanation: The EUT has one PCB Antenna, The antenna cannot be removed, Unconventional interface 2.