Users Manual

Fresh Source International Inc.
1 / 2
General Description
The AS76R is with motion activated sensor, light on when people pass by.
Via the human infrared sensor on the light that can detects whether there is any movement in
front of the luminaire. When the person is sensed, the lights automatically turn on and send a
light-on command to the outside through the 2.4G module, and the luminaire in the same lamp
group receives the light-on command. Then turn on the lights at the same time for illumination.
When the person leaves the range of luminaire sensing, the luminaire starts counting down
the set number of seconds (user configurable), and the luminaire turns off the light after setting
the number of seconds. At the same time, other lamps in the lamp group do not receive an
external light-on command, and the lights are turned off by default.
The 2.4G module is integrated in the luminaire as a communication transmission between
the lamp and the lamp. The module is in bidirectional mode and can transmit and receive signals
with an operating frequency of 3 transmit channels (2420MHz, 2450MHz and 2470MHz).
The luminaire control panel detects the ambient brightness by the photodiode to
determine the day or night. When the ambient status is detected, the control panel detects the
moving human body according to the preset mode, and makes a corresponding light-off delay
control command; The daytime status is detected, and the corresponding low-power standby
mode is entered, and the human and object movement triggers are invalid.
Block Diagram
1. VDD-power positive 3.3V,
2. GND-power negative