Safety Manual

ManualsBrandsZHONGSHAN CO-TECH INDUSTRIES ManualsElectronicsRF WALL TRANSMITTER

WC55

DC CEILING FAN WALL CONTROL (TRANSMITTER)

INSTALLATION AND OPERATION INSTRUCTION

READ AND SAVE THESE INSTRUCTIONS

Please read and understand this entire manual before attempting to install or operate the product.

Make sure that all electrical connections comply with local codes, ordinances and the National Electrical Code.

If you are unfamiliar with proper electrical wiring connections, obtain the services of a qualified electrician.

WARNING: Before proceeding, be sure to shut off electricity at main switch or circuit breaker in order

to avoid electrical shock.

NOTE: Fan installation must be complete including assembly of blades before testing wall control unit.

Refer to your Ceiling fan instruction manual for safety and installation instructions.

This wall controller is to be used for the control of DC ceiling fan and fan light only, and in an AC120V 60Hz

power supply only.

WARNING : Do not exceed maximum rating 5A of the wall transmitter. Install the wall transmitter away from

excessive heat or humidity.

IMPORTANT : Before installing the wall transmitter, place it in OFF position by pushing ON/OFF switch to OFF.

Make wiring connections with wire nuts

as shown in Fig.1.

- Connect a Black wire(marked AC IN L) from wall transmitter to the Live (Black wire) from house.

- Connect the other Black wire (marked To Motor L) from wall transmitter to Black wire from Receiver

(marked AC IN L)

- Connect yellow/green grounded wire to grounded wire from outlet box.

MOTOR

AC IN L

AC IN N

L FOR LIGHT

N FOR LIGHT

Receiver

(Yellow/ Green)

RED

GRAY

PINK

(Yellow/ Green)

WHITE

BLUE

Earth

FAN

OFF

Live In (Black)

Neutral (White)

And Install the canopy to the mounting

bracket use the screws provided.

Mounting

Bracket

CEILING

Figure 1

Outlet box

AC INPUT

Black (To Motor L)

TO RECEIVER(L)

GROUND WIER

Black (AC IN L)

(YELLOW/GREEN)

WHITE

BLACK

Power Supply

120V AC 60Hz

www.rplighting.com | 4931 Paseo Nel Norte NE, Albuquerque, NM 87113 | 800.937.6925

www.rplighting.com | 800.937.6925

4931 Paseo Nel Norte NE, Albuquerque, NM 87113

Summary of content (3 pages)

PAGE 1
WC55 DC CEILING FAN WALL CONTROL (TRANSMITTER) INSTALLATION AND OPERATION INSTRUCTION READ AND SAVE THESE INSTRUCTIONS Please read and understand this entire manual before attempting to install or operate the product. Make sure that all electrical connections comply with local codes, ordinances and the National Electrical Code. If you are unfamiliar with proper electrical wiring connections, obtain the services of a qualified electrician.
PAGE 2
INSTALLATION AND WIRING Risk Of Electric Shock ˙SHUT OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE INSTALLATION. ˙Remove the top panel from transmitter unit then install 23A 12V battery(included) in wall control, with fan power off (push on-off switch to OFF position). ˙Re-attach top panel after installing battery. Outlet box ˙Install the wall transmitter unit to outlet box using machine screws. ˙Attach wall plate to wall transmitter unit with screws provided as shown in Fig.2.
PAGE 3
§ 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.