Instruction Manual

Instruction Manual

Operating Instructions

Notes: The receiver must be located within 100 feet of the remote transmitter.

Actual functional range may be affected by the following factors: weather,

radio frequency interference, low remote battery, and obstructions between

the transmitter and receiver.

1. Remove the isolation tap in the battery compartment on the transmitter.

2. Plug the receiver into a powered outlet.

3. Plug your device into the socket of the receiver.

4. To control your matching devices:

1) Press the ON/OFF button on the transmitter.

2) Or press the programming button on the receiver.

3) The indicator light of the receiver turns on when the unit is activated.

To program a remote transmitter and receiver

1. Plug the receiver into the socket.

2. Press and hold the program button on the receiver until the indicator

light starts to blink slowly.

3. Release the program button, then press the on/off button on the

transmitter.

4. When the indicator light stops flashing, the program is paired

successfully.

Repeat Step 1-4 to pair multiple transmitters and receivers.

Cancel All Programming

Cancel all the programs so that no remote transmitter can control it.

- Press and hold the program button on the receiver until the indicator

light starts to blink rapidly.

Note: The indicator light blinks from slow to fast.

- Release the program button, then press it again, the indicator light will go

off, which means cancel the program successfully.

No Interference

Remote control outlets adopt variable learning codes technology.The codes

will be changed each time after re-programming. If this remote control outlet

happens to be in the same channels with other RF remote devices, just

re-program it and the interference will be eliminated.

Battery Replacement

If you find the receivers works abnormally or the indicator on the remote

control becomes dim, please replace the battery.

- Open the battery compartment and remove the old battery.

- Install a new CR2032 battery, making sure the polarity + / - of the battery

is correct.

- Close the battery compartment.

PAGE 1
Instruction Manual Operating Instructions Notes: The receiver must be located within 100 feet of the remote transmitter. Actual functional range may be affected by the following factors: weather, radio frequency interference, low remote battery, and obstructions between the transmitter and receiver. 1. Remove the isolation tap in the battery compartment on the transmitter. 2. Plug the receiver into a powered outlet. 3. Plug your device into the socket of the receiver. 4.
PAGE 2
Specifications - Transmission Frequency: 433.92 MHz - Remote Control Range : 100 Feet (Free Area) - Remote Battery: CR2032 3V FCC STATEMENT This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 3
Le présent appareil est conforme Après examen de ce matériel aux conformité ou aux limites d’intensité de champ RF, les utilisateurs peuvent sur l’exposition aux radiofréquences et la conformité and compliance d’acquérir les informations correspondantes. One Year Limited Warranty Supported by our professional R&D team and QC team, we provide One Year Warranty for materials and workmanship from the purchase date.