Personnel Tag User manual Zhejiang Zhier Information Technology Co., Ltd. Version, Manual Vision 1.
Table of Contents 1. Application ....................................................................................................... 1 2. Product composition .................................................................................. 1 3. Specifications .................................................................................................. 2 4. Installation ....................................................................................................... 2 5.Precautions ..........
1.Application It is used for personnel location management, The badge obtains the address information of the IOT equipment that the person passes through according to the arranged IOT network equipment, and then transmits the address information to the map server to draw the track map. 2.Product composition The personnel tag is composed of the upper clip, the middle alarm module, the lower card sleeve, and the rechargeable battery. As shown in Figure 1 below.
3.Specifications 1. Frequency: Support 433MHz, 125KHz reception. 2. Working voltage: 3.7VDC. 3. Working temperature and humidity: 5 ℃ -40 ℃, 0-90% RH. 4. Atmospheric pressure: 860hPa-1060hPa 5. Size, length * width * height = 79mm * 32mm * 12mm. 6. Equipment battery capacity: 3.7VDC, 50mAh 7. Charging interface: TyPC. 8. Charging power supply: input 100-240VAC, 50 / 60Hz, 0.15A; output 5VDC, 1A 4.Installation This product is divided into upper and lower parts.
.Precautions 1. There is a built-in spring pull-tab in the drawstring, which is forbidden to be pulled cyclically. 2. The alarm module has a built-in power warning light. When the battery has no power, it will blink red at intervals. 3. This product is waterproof design, but it has a built-in rechargeable battery. It is strictly forbidden to clean it in boiling water to prevent damage to the battery. 4.
9. Basic Troubleshooting Table1, Troubleshooting list SN Problem 1 Solution 1. Check whether the power indicator flashes when pressed. If it does not, it means that there is no power and needs to be charged. 2. The indicator light will be on and there is still no response. Check whether it is under the area covered by the IOT. 3. If there is no response after the previous test,Please return to our company for repair. Call button does not respond. 1. Check whether the interface is well contacted. 2.
CE Caution: Use the Product in the environment with the temperature Between -10℃ and 40℃; Otherwise, it may damage your product. Products can only be used below 2000m altitude For the following equipment: Product Name: RFID Personnel Tag Brand Name: -Model No.: E-SB01 Zhejiang Zhier Information Technology Co., Ltd. E-mail: qiliping@enjoyor.net The product shall only be connected to a USB interface of version USB2.0 and that the connection to a power USB is allowed.
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.