Baby Tag Product instructions ZHEJIANG ZHIER INFORMATION TECHNOLOGY CO., LTD. version number : Manual Vision 1.
Catalogue I. Scope of application and scenario II. Product composition III. Product performance and basic parameters IV. Product installation and use V. Cautions VI. Methods of product maintenance VII. Product transport VIII. Product storage IX. Analysis of basic failures X.
I. Scope of application and scenarios Application: suitable for infant anti-theft system, Baby Tag has reliable anti-damage characteristics, from the moment the label is put on, the label constantly automatically emits signals, so that the system can be monitored at any time. Without authorization, any attempt to remove or break the label triggers an alarm. The wristband used with the label can be adjusted to suit different babies, but not reused.
1.Frequency: Support 433.8MHz、125KHz receive. 2. Operating voltage: VDC.3.7 3. Working temperature and humidity :5℃-40℃,0-90% RH. 4. Atmospheric pressure: hPa-1060hPa 860 5. Size: length*width*high =33 mm*28.2mm*12.3mm 6. Equipment battery capacity :3.7 VDC,30mAh. IV.
to the server according to the locator, and the server draws the trajectory map according to the positioning signal. Wireless charging function of Baby Tag: Baby Tag adopts wireless charging technology, when low power alarm, make wireless charging seat charge the label. The indicator light of the base will flicker slowly (interval 2.5 seconds) when charging, and the indicator light will always light when full. Figure 4. Fig .4 Baby Tag wireless charging V. Cautions 1.
VII. Product transport The packaged products can be transported by ordinary means of transport, the ambient temperature in transit should be in the range of -10℃-55℃, the relative humidity is less than 95%, and the strong shock, vibration, extrusion and moisture should be prevented during transportation. VIII. Product storage 1. Avoid splashing rain and direct sunlight; 2. Should be kept in a dry, well-ventilated, non-corrosive room. 3. The ambient temperature is -10℃-55℃ and the relative humidity is ≤95%.
trigger the alarm you should charge in time after application. 2.Check whether the wristband has pull marks, if there is a need to replace the wristband. 5. If there is no response to the previous trial, you need to return our company to repair. 1. Check the charging base and Baby Tag when charging whether the corresponding suction good, re-suction to see if recovery. 2. Change the charging base to see if it is restored. 3.
CE Caution: Use the Product in the environment with the temperature Between -10℃ and 40℃; Otherwise, it may damage your product. Products can only be used below 2000m altitude For the following equipment: Product Name: Baby Tag Brand Name: -Model No.: E-RT500 Zhejiang Zhier Information Technology Co., Ltd. E-mail: qiliping@enjoyor.net This product is intended for sale and application in a business environment.
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.