Remote controller: 152Y 152Y--USER’S MANUAL Control box (works with remote controller) :152Y
I.
II. PAIRING THE WIRELESS REMOTE STEP 1: Push in on bottom of remote to release battery cartridge and install three STEP 3: AAA batteries into the remote battery compartment.Push in firmly to Press “SW” until the backlight LED flashing ,release it and then press “HEAD UP” ,never release until the backlight LED is lighting close. all long,the remote is pairing and release it.
III. FUNCTIONAL OPERATING FOR WIRELESS REMOTE MARK STEP1 STEP2 FUNCTIONAL DESCRIPTIONS The backlight LEDs all OFF before operating. TV Press(TV,ZG,M)until the backlight LED is lighting and the memory position is completed. ZG MEMORY POSITON When the backlight LED is lighting and press again, clear the corresponding memory position. M Press “SW” in 3s until the TV & ZG have the memory position ,M no memory position. BACK UP PAIRING Pairing the remote and control box.
IV. FUNCTIONAL OPERATING FOR WIRELESS REMOTE Power supply: Input: 100-240V ~, 50/60Hz Output:29.0V 3.
Product interface description The interfaces in the red box below are only used for engineering testing and are not open to consumers.
FCC/ISEDC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.