Installation Instructions

FCC ID: 2ATIITTDC-YK2019
OPERATION
REMOTE CONTROL
NOTE:Maximum range remote control: 15m
NOTE: Remove the protective strip from the remote control's battery compartment
before operation.
Switching on/off
- To switch on the product, press the ON button.
- To switch off the product, press the OFF button.
Timer
- To activate the timer mode, press the TIMER button. The green timer indicator
lights up on the controller of lighting-chain.
NOTE: Once the timer mode is activated, the product operates in 8 hours on - 16
hours off cycles.
- To deactivate the timer mode, press the TIMER button again. The green timer
indicator goes off.
Lighting modes
- Press the 1 to 8 button to choose the desired mode. Choose from:
1 Steady on
2 in waves
3 sequential
4 slo-glo
5 chasing/flash
6 slow fade
7 twinkle/flash
8 combination
BATTERY REPLACEMENT
1.Press the tab on the side of the battery compartment's tray.
2.Side out the tray.
3.Take out the exhausted battery and dispose of properly.
4.Place a new CR2025 battery on the tray. Ensure the correct polarity.
5.Slide the tray back into the battery compartment.

Summary of content (2 pages)