Specifications

This product is a standard Qi wireless charger, which supports wireless charging for all
kinds of mobile phones (including Samsung S7, Note8, iPhone 8, iPhone, etc.) or other
devices in line with the Qi charging protocol. It can output up to 10W of charging power,
and the charging distance can meet the range of 0mm to 8mm.
1.0 Electrical Specification
Model JCP35W3
Voltage Range
4.3Vdc-9.7Vdc
Rated Voltage 5/9Vdc
Charge Distance 0mm-8mm
Standby Power Consumption ≤1W
Rated Input Current 2A
Efficiency 70%
Input Over-Current Protection （Ping Phase） 0.5A
Input Over-Current Protection （Power Transfer Phase） 2A
Input Over-Voltage Protection 9.7V
Input Over-Voltage Protection 4.3V
2.0 Working status indication
2.1 Charge Status Indication
Charger Stat
us Power On Standby Charging Battery Full Fault
Blue LED Blink（1Hz）1 time OFF ON OFF Blink（1Hz）
The transmitter has five working states, namely, power on, normal standby, normal
charging, full power and failure. After the power on, the red light is always on, and the green
light does not glow after flashing 1 times; When the normal standby, the red light is always
on; When charging normally, the green light is always on and the red light is off; When
abnormal or malfunction occurs, the green light blinks and the red light goes off. Abnormal
phenomena include over-offset location of the receiver, over-high PCBA temperature, entry
of metal foreign matter, overcurrent of input current, and overvoltage of input voltage, etc.
3.0 Protection Character
3.1 Input Over-Current Protection
The Qi transmitter has the input current overcurrent protection. Once the overcurrent
fault is triggered, the transmitter will automatically shut down and restart, and try to
reconnect. If the overcurrent protection is triggered for many times, the system will stop
working and flash the light to alarm.
3.2 Coil Over-Current Protection
The Qi transmitter has the primary side coil current overcurrent protection. Before
entering the power transmission stage, once the overcurrent fault is triggered, the
transmitter will automatically shut down and restart to try to reconnect. If an overcurrent is
triggered after entering the power transmission stage, the emitter will automatically adjust
the current to below the current limit point.
3.3 Foreign body detection Protection FOD Protection
The Qi transmitter has the function of foreign body detection. When the transmitter