User's Manual

ManualsBrandsZHEJIANG JIECANG LINEAR MOTION TECHNOLOGY ManualsElectronicsRF Remote Control

JCHR35H6C1 Remote control User manual

1、Remote control Effect Picture

2、Remote control function description

2.1 Pairing:

Remote control pair code:

1) put the battery into the remote control.

2) power the control box (supporting our control box).

3) at the same time, hold down the head up button on the remote control and the foot up button.

When the LED on the control box to be matched stops flashing and the buzzer makes a sound, the

pairing operation is completed. To test whether or not the pairing is successful, head up/down, foot

up and down keys, buttons and so on related to drive, if you can hear the "tick" sound emitted by

the relay, specification matching success. Otherwise, repeat all the above steps.

Note: after successful code alignment, operate any two buttons at the same time during use, and

the remote control will not send signals.

3、Function description

3.1 Learning function: after the controller is powered on or long press the learning button, it enters

Summary of content (4 pages)

PAGE 1
JCHR35H6C1 Remote control User manual 1、Remote control Effect Picture 2、Remote control function description 2.1 Pairing: Remote control pair code: 1) put the battery into the remote control. 2) power the control box (supporting our control box). 3) at the same time, hold down the head up button on the remote control and the foot up button. When the LED on the control box to be matched stops flashing and the buzzer makes a sound, the pairing operation is completed.
PAGE 2
the learning state. The green light of the controller keeps flashing. In the learning state, press the "head up" and "foot up" buttons of the remote control at the same time until the controller will emit a "tick". At the same time, the blue headlight of the remote control flashes twice to indicate that the learning is completed, and the green light of the controller stops flashing. 3.
PAGE 3
to control bed A, dial B to control bed B, and dial AB to control bed A and bed B at the same time. 3.4 Low power consumption function: when the button is pressed, the remote control starts to work, and the headlight lights up. If the button is not pressed for more than ten seconds, the remote control enters into low power consumption, and the headlight goes out.
PAGE 4
6、Remark A、FCC 15.21 Information to user Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. B、FCC 15.19 Information to user This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.