User's Manual

ManualsBrandsZHEJIANG JIECANG LINEAR MOTION TECHNOLOGY ManualsElectronicsRF Remote Control

JCHR35H6B1 Remote control User manual

1、Remote control Effect Picture

2、Remote control function description

2.1Pairing:

Remote control pair code:

1) put the battery intothe remote control.

2) power the control box (supporting our control box).

3) at the same time, hold down the head up button on the remote control and the foot up button.

When the LED on the control box to be matched stops flashing and the buzzer makes a sound, the

pairing operation is completed. To test whether or not the pairing is successful, head up/down,

head up and down keys, buttons and so on related to drive, if you can hear the "tick" sound

emitted by the relay, specification matching success. Otherwise, repeat all the above steps.

Note: after successful code alignment, operate any two buttons at the same time during use, and

the remote control will not send signals.

Summary of content (4 pages)

PAGE 1
JCHR35H6B1 Remote control User manual 1、Remote control Effect Picture 2、Remote control function description 2.1Pairing: Remote control pair code: 1) put the battery intothe remote control. 2) power the control box (supporting our control box). 3) at the same time, hold down the head up button on the remote control and the foot up button. When the LED on the control box to be matched stops flashing and the buzzer makes a sound, the pairing operation is completed.
PAGE 2
3、Function description 3.1 Learning function: After the controller is powered on or long press the learning button, it enters the learning state. The green light of the controller keeps flashing. In the learning state, press the "head up" and "foot up" buttons of the remote control at the same time until the controller will emit a "tick". At the same time, the blue headlight of the remote control flashes twice to indicate that the learning is completed, and the green light of the controller stops flashing.
PAGE 3
4、Key value to code table Remote control pictures Button icon key definitions key value M1 push rod up 0X01 M1 push rod down 0X04 M2 push rod up 0X02 M2 push rod down 0X05 FLATlocation 0X08 ZG location 0x07 Remarks 5、Others 5.1. The operating frequency range： 2404 MHz-2479MHz; 5.2.Number of working channels of remote control is 5： 2404,2419,2454,2469,2479. And 2479 is the code channel. 6、Remark A、FCC 15.
PAGE 4
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1)L’appareil ne doit pas produire de brouillage; (2)L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.