User's Manual

ManualsBrandsZHEJIANG JIECANG LINEAR MOTION TECHNOLOGY ManualsElectronicsControl System

User Manual

1. Function description

These devices are micro-processor based, electronic controllers mainly intended

for controlling external loads, such as motors, actuators and lightings etc.,

designed to be incorporated massage equipment.

2. Description of load type and connection of each circuit

The control box JCB35H7B2 interface can connect four DC motor actuators,

two DC massage motors ,one LED light, one Bluetooth receiver box,

Corresponding interfaces are respectively identified as Head Motor, Foot Motor,

Neck Motor , Foot Motor ,Head Motor , LED and APP, The POWER port is the

supply port of the control box.

·Connections diagram as follows

3. Limitation of the DC actuators

Summary of content (5 pages)

PAGE 1
User Manual 1. Function description These devices are micro-processor based, electronic controllers mainly intended for controlling external loads, such as motors, actuators and lightings etc., designed to be incorporated massage equipment. 2.
PAGE 2
When any one DC actuator works, other DC actuators will not work; and the duty cycle of these actuators is 10%, with Max. 2 minutes operate and Min. 18 minutes stop duration.’ or the equivalent. 4. Safety instructions 1) WARNING: For indoor use only. 2) For use in pollution degree 2 environment. 3) Rated impulse voltage 330V 4) Class III ‘ ’symbol; 5. Specifications JCB35H7B2 Actuator quantity 4 Duty cycle 10%, with Max. 2 minutes operate and Min. 18 minutes stop duration.
PAGE 3
JCB35H7B2dimension and connection 6. Basic Settings Press button and not release, the actuator M1 move up, release the button, the actuator stop moving; Press button and not release, the actuator M1 move down, release the button, the actuator stop moving. Press button and not release, the actuator M2 move up, release the button, the actuator stop moving; Press button and not release, the actuator M2 move down, release the button, the actuator stop moving.
PAGE 4
Memory location A Memory location B ZG location ANTISNORE location Night light motor work motor stop motor work The control box is paired with the remote control Pairing function: after the control box is powered on, the control box enters the learning state, and the green light of the control box flashes continuously. In the learning state, press the "back up" and "leg up" buttons of the remote control at the same time until the control box will emit the voice "di".
PAGE 5
FCC Statement： Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation.