Owners manual

ManualsBrandsZEX ManualsAutomotiveZex 82175 Dual Outlet Nitrous Purge Kit

ZEX™

3418 Democrat Rd.

Memphis, TN 38118

Phone: 1-888-817-1008 Fax: (901) 375-3430

www.zex.com

Part #ZEX174

Revised 6/13/06

Dual Outlet Purge Kit #82175

Thank you for choosing ZEX™. If at any time you have questions regarding this or any of our

products, please call our NITROUS HELP™ support line at 1-888-817-1008.

Read this installation manual completely before attempting to install your Dual Outlet Purge Kit.

Failure to do so may result in damage to your engine or vehicle and/or physical harm to yourself.

ZEX™ is not responsible for damage or injuries caused by improper use of this purge kit.

Installation Instructions

1. For safety, disconnect the

positive (+) and negative (-)

cables from the battery while

installing the ZEX™ Dual

Outlet Purge Kit.

2. Disconnect the -4AN main

nitrous delivery line at the

Nitrous Management Unit or

solenoid inlet, depending on

what type of nitrous system

you have (Fig. A).

INSTRUCTIONS

Nitrous Inlet Fitting

-3AN Deliver

Line

90° -3AN Fitting

-4AN Main Nitrous

Delivery Line

-4AN In-Line Adapter

Fig. A

Summary of content (3 pages)

PAGE 1
INSTRUCTIONS Dual Outlet Purge Kit #82175 Thank you for choosing ZEX™. If at any time you have questions regarding this or any of our products, please call our NITROUS HELP™ support line at 1-888-817-1008. Read this installation manual completely before attempting to install your Dual Outlet Purge Kit. Failure to do so may result in damage to your engine or vehicle and/or physical harm to yourself. ZEX™ is not responsible for damage or injuries caused by improper use of this purge kit.
PAGE 2
3. Attach and tighten the -4AN in-line adaptor to the NMU/nitrous solenoid inlet fitting. At this point, you may turn the inlet fitting with the in-line adapter tightened to it, clockwise, to achieve the desired inline adaptor position. The inlet fitting uses a pipe thread, so the additional turning in the clockwise direction should be kept to a minimum. Do not overtighten the inlet fitting (Fig. B). Fig. B 4. Reconnect the main nitrous delivery line to the inlet of the -4AN in-line adaptor. 5.
PAGE 3
11. Locate a 12 volt source wire and splice into it with the red t-tap electrical connector. Attach the .250 in. wide male electrical connector to a length of the supplied wire and connect it to the t-tap. Install the in-line fuse holder and fuse on this wire lead and run the remaining length of wire through the hole you have just drilled for the activation switch. On this end of the wire, crimp on one of the .187 wide female connectors. 12. Cut another length of wire and feed it through the same hole.