User's Guide

USER GUIDE
Knob
Micro USB
Mode Switching
RESET
LED
Reset Hole
Audio Jack
MARINE Adapter
x1
Paddle
x2
Paddle(s)
x2
Lock Tool
x1
User Guide
x1
USER GUIDE
Product Introduction
MARINE enables your PS4 controllers to be
used on PS4,PS3,Switch,Android,Mac/iOS
and PC. MARINE also supports Turbo and
Remap function with 4 additional paddles,
which can be completely customized. And it
is suggested that a fully charged 18650
lithium battery be installed before playing.
Paddle
x2
Paddle(s)
x2
Battery Latch
Paddle
Paddle
(S)
Paddle
Paddle
(S)
18650
18650 Battery
Lock
Controller Connector
Battery Cover
Switch mode
How to install MARINE
Replace the battery
and paddles
Firmware Upgrade
User Guide
Power Off
Android
Power Off
PC
Nintendo
Switch
Mac / iOS
Play
Station 3
Backup
Play
Station 4
Firmware
Upgrade
1. Use the attached Lock Tool
to loosen the cover of the
lower edge of MARINE
1. Press and hold the battery latches on both
sides of the MARINE to open the battery cover.
2. Place the fully charged 18650 lithium battery.
Be sure to confirm that the battery is in the
correct direction.
3. Insert or remove the paddles according to
your requirement.
4. Relock the battery cover.
This product has 2 versions, "Battery version" and "Non Battery
version". When you choose to purchase MARINE with "Battery
version", it includes a 3350mAh 18650 Lithium Battery, which
takes 4 hours to be fully charged and 8 hours continuous use.
However, if you purchase the “Non Battery version”, please
remember to purchase a 18650 Lithium Battery.
3. Place MARINE
carefully into PS4
controller.
2. Attach the lock cover
to PS4 Controller.
More about LED signal
：
4. Sit the lock cover to MARINE, don't forget
to relock it.
BROOK always provides the complete user
manual, product information, demonstration
film and latest firmware version. Please visit the
official website to confirm:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1
2
Note:
1. The Remap Setting in each Mode will be memo-
rized. For example: you make a Remap Setting in
PS4 mode, then switch to NS Mode. The next time
you switch back to PS4 mode, the Remap Setting in
PS4 mode still remains.
2. The default currently of Backup Mode has no
function, it is reserved for possible future product
upgrades.
Note:
NOTE
Status LED
Knob LED
Blue
Cyan
Orange
Green
White
Yellow
--
Purple
No light:
MARINE is in sleep mode.
Red Light:
Low battery, you can replace the battery or
plug for charging. Charging and playing
simultaneously is supported.
When Knob is charging in Power Off mode, LED
displays orange flashing light. When the power if
full, it displays green light.
Orange Flashing Light:
Enter Brook's website or scan
the QR code for User Guide
with multi-languages and the
latest information
Product information and
demonstration film
Easy operation
ver.EN-CHT-1910
Brook Key
2 3 4
6
5
7 8 9 10
FCC Statement:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and
receiver.
—Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
Firmware update
User Guide
information
About MARINE
80mm 80mm 80mm 80mm 80mm
110mm
110mm
CCXXxxLPyyyZzW
FCC ID 2ADKMN009
Label: Brook P/N: ZPMN02C