Use, Care, and Installation Guide www.zephyronline.com In-Line Blower PBN-1000A E12733 4 Model number: Serial Number: SEP14.0201 © Zephyr Ventilation LLC.
www.zephyronline.
INSTALLATION Ductwork Calculation Sheet.................................... Blower Positions........................................................... Specifications................................................................ Mounting the Blower................................................... 1 4 5 6 7 Table of Contents SAFETY NOTICE.................................................................. 2 LIST OF MATERIALS........................................................
www.zephyronline.com Important Safety Notice READ AND SAVE THESE INSTRUCTIONS ! FOR DOMESTIC COOKING ONLY ! WARNING WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty. 2.
! POUR LA CUISSON DOMESTIQUE ! AVERTISSEMENT AVERTISSEMENT POUR RÉDUIRE LES RISQUES D’INCENDIE, DE DÉCHARGE ÉLECTRIQUE OU DE BLESSURE, RESPECTEZ CES CONSIGNES : 1. N’utilisez cet appareil que de la manière prévue par le fabricant. Si vous avez des questions, communiquez avec le fabricant. 2.
List of Materials www.zephyronline.
Equivalent number length x used = Duct pieces Total Total 3-1/ 4” x 10” 1 Ft. Rect., straight x( ) = Ft. 6” Round 30 Ft. wall cap with damper x( ) = Ft. 6” Round, straight 1 Ft. x( ) = Ft. 6” Round, roof cap x( ) = Ft. 7”-10” Round, 1 Ft. x( ) = Ft. x( ) = Ft. 3-1/ 4” x 10” 15 Ft. Rect.90 0 elbow x( ) = Ft. 6” round to 1 Ft. 3-1/ 4” x 10” rect. transition x( ) = Ft. 3-1/ 4” x 10” 9 Ft. Rect.45 0 elbow x( ) = Ft. 6” round to 16 Ft. 3-1/ 4” x 10” rect.
Installation – Blower Positions www.zephyronline.com let out 4 5 2 outlet 1 outlet outlet Plywood 3 WARNING: Check installation position so that the blower outlet is exhausting air away from the hood and out of the home. 1. 2. 3. 4. 5.
Installation – Specifications front side (bracket positions) 1 9/16” outlet 7 5/16” 6 13/16” 15 7/8” 20 15/16” 1 11/16” 7 5/16” 1/ 16 ” 21 7/8” 23 7/16” 14 3/16” 7 11 13/16” 14 5/8” 10 8 5/8” bottom (inlet) 10 3/8” 5 1/2” 6” 3 4 top (outlet) 5/1 bracket 2 20 3/8” 91 outlet 1
Installation – Mounting the Blower www.zephyronline.com 1. Determine blower position (examples on page 5). Install each of the (2) mounting brackets to the sides of the in-line blower housing using (4) M4x8 screws per bracket. There are possible (4) mounting positions for the brackets. FIG. A Note: Brackets must be secured to studs using (2) M4 x 1-1/2” screws per bracket. 2. Run 10” round ducting to inlet and outlet of in-line blower housing. Secure with aluminum duct tape.