6001432 User’s Guide Age 12+ Dominator 2.0 Blade guard Drone 6001432_PM_En.
Contents Features............................................................................................. 3 Package Contents............................................................................. 3 Specifications.................................................................................... 3 Fly Safely............................................................................................ 3 Charge the Drone..............................................................................
We hope you enjoy your Dominator 2.0 Blade Guard Drone from RadioShack. Congratulations! No FAA Registration is required for this drone. Please read this user’s guide before setting up and using your drone.
Charge the Drone 1. Make sure the drone is turned off. 2. Connect the included USB charging cable to the drone's CHG jack and a USB power source. The USB connector LED lights red during charging, and turns off when charging is complete. CHG LED ON/ OFF A full charge takes about 55-60 minutes, and provides up to 5 minutes of flight time. 3. After charging, unplug the charging cable. Caution •• Use only the included USB charging cable to charge the drone's battery. Other cables may damage the drone.
Note: If the remote control’s LED flashes during use, the batteries are low and should be replaced. Battery Notes •• Dispose of old batteries promptly and properly. Do not burn or bury them. Use only fresh batteries of the required size and recommended type. •• Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities. •• Remove batteries during longer storage periods.
Remote Control Overview Forward / Reverse Movement Trim LED Throttle Ascend Turn left 6001432_PM_En.
6001432_PM_En.
Fly Your Drone 1. After pairing, with the drone on the ground, move the throttle forward to ascend. To avoid ground air turbulence, fly the drone at least 1 ft. (30cm) off the ground. For advanced users: Hold the remote control with one hand, resting your thumb on the throttle. Throw the drone about 9 ft. (3m) away from you, and move the throttle forward to fly. The drone adjusts itself automatically and flies smoothly. 2. For speed options, pair and fly in Ex mode.
Replace Damaged Propellers A The left and right propellers of the drone are different, and marked A/B on the propeller. You must use the correct propeller in the correct location, otherwise the drone will fail to take off. B B A To replace a damaged propeller, use a screwdriver to remove the old propeller. Insert a new matching propeller onto the propeller axle, then screw securely, but do not overtighten as the propeller then won't turn.
Drone swerves or moves erratically before taking off •• The gyroscope inside your drone needs calibrating: Do the following: 1. With your drone and remote control switched on and paired, place the drone on level ground. 2. Move the throttle all the way down. 3. Move the steering forward and hold this position for a few seconds until the drone LEDs start to blink. 4. Release the steering. The drone LEDs light steadily, indicating successful calibration. You are now ready for takeoff.
