HFDOCK - EMA DOCK NFC reader board – USER MANUAL
Contents 1 – Getting started.................................................................................................................................. 3 2 – Board setup ...................................................................................................................................... 3 2.1 Connector interface ...................................................................................................................... 4 2.2 Components placement ............................
1 – Getting started Connect EMA NFC READER BOARD to an STM32 via an SPI differential to SPI converter (LTC6820IUD). The supply voltage has to be capable of delivering at least 300 mA at 5 V supply. A demo software is available for download at www.st.com to be programmed onto an STM32.
2.1 Connector interface The connector used on EMA NFC reader board is a 12pins Wire to Board connector of 0.8mm pitch Right angle version (ENTERY 4260-F12N-00R). Here is the pins assignment: Pin # 1 2 3 4 5 6 7 8 9 10 11 12 ZEBRA CONFIDENTIAL: INTERNAL USE ONLY Name SPI_IRQ_NFC_C Ground SLAVE_IP_C SLAVE_IM_C VDD_IO_3V3_C VDD_5V_C Description Ground Ground Ground Ground Ground SPI Interrupt request Differential SPI Positive Differential SPI Negative Ground 3.
2.
3 Federal Communications Commission (FCC) and Industry Canada (IC) compliance 3.1 FCC Compliance Statement 3.1.1 Part 15.19 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 3.1.2 Part 15.
3.2 Formal notices required by Industry Canada (“IC”) 3.2.1 Compliance Statement This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: 1 This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device. 3.2.
FCC This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. ISED The products are compliant with SAR for general population/uncontrolled exposure limits in IC RSS102 and has been tested in accordance with the measurement methods and procedures specified in IEEE 1528.
7.The user manual of the end product should include: FCC 1. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. 2. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 3.
Revision History REV DESCRIPTION DATE AUTHOR 1.0 Initial Release 11/20/2019 B. LIMONGI ZEBRA and the stylized Zebra head are trademarks of Zebra Technologies Corp., registered in many jurisdictions worldwide. All other trademarks are the property of their respective owners. ©2019 Zebra Technologies Corp. and/or its affiliates. All rights reserved.
