Quick Start Guide

www.zebra.com/ds9900seriesretail
www.zebra.com/ds9900serieslab
DS9908R
ICL RS-232
NIXDORF RS-232 MODE A
*STANDARD RS-232
NIXDORF RS-232 MODE B
FUJITSU RS-232
OPOS/JPOS
NON-IBM SCANNER EMULATION (PORT 5B)
HAND-HELD SCANNER EMULATION (PORT 9B)
TABLE-TOP SCANNER EMULATION (PORT 17)
*USB KEYBOARD (HID)
IBM HAND-HELD USB
OPOS (IBM HAND-HELD with FULL
DISABLE)
SNAPI WITH IMAGING
ADD AN ENTER KEY (CARRIAGE RETURN/LINE FEED)
ADD A TAB KEY
USB - OVERRIDE CAPS LOCK KEY (ENABLE)
*USB - DO NOT OVERRIDE CAPS LOCK KEY (DISABLE)
RETURN TO FACTORY DEFAULTS
DISABLE
*2 SECONDS
CONTINUOUS
SINGLE TAG
*CONTINUOUS RE-REPORT
CONTINUOUS FLUSH
RAW
GS1-128
EPC URI
5 MINUTES
BLACK
PANTONE 307C
PerforationPerforation PerforationPerforation
DS9908R Poster
2
1
6
4
3
5
8
7
9
11
10
Post in Work AreaPost in Work Area
Quick Start Guide
Hands-Free
Imaging Scanner
See
- Product Reference Guide Supplement for detailed RFID information
- Product Reference Guide for detailed imaging information
FEATURES
CABLE INSERTION CABLE REMOVAL
RS-232
Scan ONE of the barcodes below
The imager automatically detects the host interface type and uses the
default setting. If the default (*) does not meet your requirements, scan another
host barcode below.
IBM 46XX
Scan ONE of the barcodes below
The imager automatically detects the host interface type, but there is
no default setting. Scan one of the barcodes below to select the appropriate port.
STEP 1 - CONNECT HOST INTERFACE
STEP 2 - SET UP INTERFACE (Scan Host Barcodes)
USB
Scan ONE of the barcodes below
The imager automatically detects the host interface type
and uses the default setting. If the default (*) does not meet your
requirements, scan another host barcode below.
USB
SET DEFAULTS / ENTER KEY TAB KEY USB CAPS LOCK OVERRIDE
RS-232
IBM 46XX
Set Defaults Add A Tab Key
Add An Enter Key
To add an Enter key after scanned data, scan
the barcode below.
(Carriage Return/Line Feed)
To add a Tab key after scanned data, scan
the barcode below.
3 4
1 2
RFID SAME TAG TIMEOUT RFID TRIGGER MODES
RFID DATA TRANSMISSION FORMAT
IMPORTANT: RFID CANNOT operate until RFID Country of
Operation (parameter #1583) is set to the country where the
product is used. Scan the appropriate barcode in the DS9908R
Hands-Free Imaging Scanner Product Reference Guide
Supplement (p/n MN-003377-xx) or configure with 123Scan.
5 RFID LED Indicators
6 RFID Antenna
9 Cable Release
Opening (Pinhole)
10 Interface Cable Port
11 Finger Ridge
1 Scan LED Indicator
2 Scan Window
3 Trigger A
4 Trigger B
7 Speaker
8 Hand-held Touch Zones
C
M
Y
CM
MY
CY
CMY
K
MN-003342-01a_ds9908r-qsg-en_front.pdf 1 4/18/2019 10:03:14 AM