User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. CHILDREN AND VULNERABLE PEOPLE SAFETY WARNING! Risk of suffocation, injury or permanent disability.
• • • • • • • • • • • • • • • Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation. The ventilation openings in the base (if applicable) must not be obstructed by a carpet. Ensure you have good ventilation in the installation room to avoid the back flow of gases into the room from appliances burning other fuels, including open fires.
• • • • • Never stop the wash dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. The final part of a wash dryer cycle occurs without heat (cool down cycle) to ensure that the items are left at a temperature that ensures that the items will not be damaged. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents.
• • • • If you have washed your laundry with a stain remover start an extra rinse cycle before you start a drying cycle. Make sure that you remove all metal objects from the laundry. Only dry fabrics which are applicable to dry in the washer-dryer. Follow the instructions on the fabric label. Plastic items are not heat resistant. – If you use a detergent ball, remove it before you set the drying programme. – Do not use a detergent ball when you set a non-stop programme.
CONTROL PANEL CONTROL PANEL DESCRIPTION 1 24 1 23 2 3 22 4 21 5 20 6 19 18 7 8 17 9 16 15 10 14 13 12 11 2 3 4 1400 1200 900 700 10 1 Programme knob and On/Off position 2 Display 3 Delay Start button 4 Door Locked indicator 5 Start/Pause button 9 8 7 6 5 7 Drying Time button 8 Extra Rinse button 9 Options button 10 Spin Reduction button 6 Easy Iron button DISPLAY A B • The display shows: A.
• • After the programme start, the set delay appears for few seconds, then the duration of the set programme is displayed again. Alarm codes If the appliance has a malfunction, the display shows the alarm codes. Refer to the chapter 'Troubleshooting' . Incorrect option selection The display shows the message some seconds and the Start/Pause indicator button flashes if : – You set a option that is not suitable for the programme. – You change the programme while it operates.
Maximum load Programme Maximum spin Temperature range speed Programme description (Type of load and soil level) Drying 20 3 kg Drying programme for cotton items. 2 kg Drying programme for synthetic items. 7 kg 1400 rpm To rinse and spin the laundry. All fabrics, except woollens and very delicate fabrics. Reduce the spin speed accordingly to the type of laundry. 7 kg To drain the water after programme with the optionRinse Hold set.
Programme ■ ■ ■ ■ ■ PROGRAMMES FOR TIMED DRYING Dryness Level Type of fabric Extra Dry For towelling materials Cottons and Linen (bathrobes, bath towels, etc) Cupboard Dry1) For items to put away Cottons and Linen (bathrobes, bath towels, etc) Load (kg) Spin speed (rpm) Suggested duration (mins) 4 1400 215 - 220 3 1400 160 - 180 1.5 1400 95 - 105 4 1400 205 - 210 3 1400 150 - 170 1.
Programmes Load (kg) Energy conApproximate proWater consumption gramme duration (misumption (litre) (kWh) nutes) Cottons 60 °C 7 1.35 67 150 Cottons Economy Cotton Energy Saving Programme 60 °C1) 7 1.05 49 180 Cottons 40 °C 7 0.85 67 140 Synthetics 40 °C 3.5 0.55 42 90 Delicates 40 °C 3.5 0.55 63 65 2 0.
Furthermore, the appliance will perform some additional rinses in some programmes. On cotton programmes the maximum spin speed is reduced automatically. DELAY START With this option you can delay the start of a programme from 30 minutes to 20 hours. The display shows the related indicator. DOOR LOCKED INDICATOR DOOR The indicator Door shows when the door can be opened: • The indicator is on: the door cannot be opened. • The indicator flashes: the door is opening in some minutes.
DETERGENT COMPARTMENTS Detergent compartment for prewash phase. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). USING DETERGENT AND ADDITIVES 1. Measure out the detergent and the fabric conditioner. 2. Put the detergent and the fabric conditioner into the compartments. 3. Carefully close the detergent drawer. SETTING A PROGRAMME 1. Turn the programme knob to switch the appliance on and set the programme: flashes.
OPENING THE DOOR While a programme or the operates, the appliance door is locked. The indicator is on. CAUTION! If the temperature and level of the water in the drum are too high and the drum still rotates, you cannot open the door. To open the door during the first minutes of the cycle or when the operates: 1. Press the button to pause the appliance. 2. Wait until the indicator 3. You can open the door. goes off. 4.
• • Each time you press this button the time value increases by 5 minutes. As the appliance calculates also the duration of the anti-crease and the cooling phases, the programme time will automatically increase by some minutes. 2. Press button to start the programme. • The display shows regularly a new time value. • The indicator is on. If you set only 10 minutes of drying, the appliance performs only a cooling phase. If the laundry is not sufficient dry, set again a short drying time.
FLUFF IN THE FABRICS During the washing and/or drying phase, some types of fabric, (sponge, sweatshirt) could release fluff. The released fluff could stick to the fabrics during the next cycle. This inconvenient increases with technical fabrics. To prevent the fluff in your laundry, we recommend that you: • • • • To do not wash dark fabrics after you washed and dried light coloured fabrics (new sponge, sweatshirt ) and the contrary.
• • Do a check if the connection of the drain hose is correct. Refer to installation chapter for more information. For the maximum laundry load of the drying programmes, refer to the drying programmes table. ITEMS NOT TO DRY Do not set a drying programme for this laundry: • Very delicate items. • Synthetic curtains. • Pieces of clothing with metal inserts. • Nylon stockings. • Quilts. • Bed covers. • Duvets. • Anoraks. • Sleeping bags • Fabrics with residue of hair sprays, nail solvents or similar.
DOOR SEAL CAUTION! Switch the appliance off and remove the mains plug from the socket. Regularly examine the seal and remove all objects from the inner part. CLEANING THE DETERGENT DISPENSER Clean regularly the washing powder and additive dispenser drawer. • Press the catch downwards and pull it out to remove the drawer. • Flush it out under a tap, to remove any traces of accumulated powder. • Proceed as follows: • Unplug the appliance. • If it is necessary, wait until the water has cooled down.
• 2 • 1 • Put the cap back on the emergency emptying hose and place the latter back in its seat. Replace the filter into the pump, insert it correctly into the special guides. Screw the pump cover firmly. Turn it clockwise. CAUTION! When the appliance is in use and depending on the set programme there can be hot water in the pump. Never remove the filter during a washing cycle, always wait until the appliance has finished the cycle, and is empty.
EMERGENCY EMPTYING OUT If the appliance does not drain the water, proceed as follows: 1. Disconnect the mains plug from the mains socket. 2. Close the water tap. 3. If necessary, wait until the water has cooled down. 4. Place a bowl on the floor and put the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. 5. When the bowl is full, put the cap back on the emergency hose. 6. Empty the bowl. Repeat the procedure until water stops flowing out.
Problem The appliance does not drain the water. Possible solution • • • • • • The spin phase does not operate or the washing cycle lasts longer than usually. • • • There is water on the floor. • Set the spin programme. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems.
After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Authorised Service Centre. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Service. SERVICE We recommend the use of original spare parts. When contacting the Authorised Service Centre, make sure that these data are available.
• • • • Level the appliance by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the appliance MUST be level and stable. If necessary, check the setting with a spirit level. Any necessary adjustment can be made with a spanner. • After having levelled the appliance, tighten the lock nuts. • Accurate levelling prevents vibration, noise and displacement of the appliance during operation. • Connect the hose to a tap with a 3/4”thread.
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre BUILDING IN OVERVIEW This appliance has been designed to be built into the kitchen furniture. The recess should have the dimensions shown in the picture below: 600 mm min. 596 mm 560 mm 555 mm min. 820 mm 818 mm 75 mm 60 mm 170 mm 100 mm We recommend that you keep the packaging and the transit bolts for any movement of the appliance.
16-22 mm X Ø 35 mm 416 mm A 22±1,5 mm 14 mm 595-598 mm Hinges To mount the hinges drill two holes (dia. 35 mm, depth 12.5-14 mm depending on the depth of door furniture) on the inner side of the door. To fix the hinges to the door use the screws for wood 1 and 2 supplied with the appliance (see below). B To align the door perfectly, loosen the screw, adjust the door and tighten the screw A again. The appliance is prearranged for a magnetic closure of the door.
D A C E B TECHNICAL DATA Dimension Width/ Height/ Depth/ Total depth 596 mm/ 820 mm/ 544 mm/ 544 mm Electrical connection Voltage Overall power Fuse Frequency 220-230 V 2000 W 10 A 50 Hz Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture IPX4 Water supply pressure Minimum Maximum 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) Maximum wash load Cotton 7 kg Maximum dry load Cotton S
132928353-C-362015 WWW.ZANUSSI.