EN User manual Washer-dryer ZWT 71401 WA
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Use - Drying _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Drying Hints _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 12
• After having installed the appliance, check that it is not standing on the inlet and drain hose and the worktop is not pressing the electrical supply cable against the wall. • If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. • Always be sure, that there is no water leakage from hoses and their connections after the installation.
door, rotate the button anticlockwise until the groove is vertical. Product description Your new appliance meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. Its new washing system allows total use of detergent and reduces water consumption so saving energy. 2 1 3 4 5 6 4 1 Detergent dispenser drawer 2 Control panel 4 Rating Plate 5 Drain pump 3 Door opening handle 6 Adjustable feet www.zanussi.
Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash. If using liquid detergent pour it just before starting the programme. Compartment for liquid additives (fabric softener, starch).
Rinse hold By selecting this function the water of the last rinse is not emptied out to prevent the fabrics from creasing. Before opening the door it will be necessary to empty out the water. To empty out the water, please read the paragraph «At the end of the programme». Super Quick Short cycle for lightly soiled items or for laundry which needs only freshening up. We recommend you to reduce the fabrics loading.
The Selected delay set by pressing the relevant button appears on the display for few seconds, then the duration of the selected programme is displayed again. • Alarm codes In the event of operating problems, some alarm codes can be displayed, for example E20 (see paragraph «What to do if...»).
if the selected programme/option it requires (see more details in «Detergent dispenser drawer»). Reduce the spin speed by pressing button 2 By selecting a programme, the appliance proposes automatically the maximum spin speed provided for that programme. Press button 2 repeatedly to change the spin speed, if you want your laundry to be spun at a different speed. The relevant light illuminates.
Important! The selected delay can be changed only after selecting the washing programme again. The Delay Start can not be selected with DRAIN programme. Start the programme by pressing button 8 To start the selected programme, press the button 8, the green pilot light of the button 8 stops blinking. To interrupt a programme which is running, press the button 8: the green pilot light starts blinking. To restart the programme from the point at which it was interrupted, press the button 8 again.
4. 5. 6. If you wish to select a timed drying, press button 5 until the time you want appears on the display (see the «Drying Programme» table). Every time you press this button the drying time increases by 5 minutes. Note! The programme time will automatically increase by some minutes. Press button 8 to start the programme. After the programme has started, the time remaining is updated every minute.
Temperatures The following weights are indicative: 95° or 90° for normally soiled white cottons and linen (e.g. tea cloths, towels, tablecloths, sheets...) 60°/50° for normally soiled, colour fast garments (e.g. shirts, night dresses, pyjamas....) in linen, cotton or synthetic fibres and for lightly soiled white cotton (e.g. underwear) 40°-30°- Cold for delicate items (e.g.
Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste. Detergents and additives Good washing results also depend on the choice of detergent and use of the correct quantities to avoid waste and protect the environment. Although biodegradable, detergents contain substances which, in large quantities, can upset the delicate balance of nature. The choice of detergent will depend on the type of fabric (delicates, woollens, cottons, etc.
If using liquid detergents, a programme without prewash must be selected. Your appliance incorporates a re-circulation system which allows an optimal use of the concentrated detergent. Follow the product manufacturer’s recommendations on quantities to use and do not exceed the «MAX» mark in the detergent dispenser drawer.
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options 9–12 Sintéticos 60°- Frío Main wash - Rinses Short spin at 900 rpm Max. load 3,5 kg - Reduced load 2 kg 1) Synthetic or mixed fabrics: underwear, coloured garments, nonshrink shirts, blouses. Centrifugado Agua en cuba Económico2) Super Rápido AquaCare Planchado fácil 13–15 Delicados 40°- Frío Main wash - Rinses Short spin at 700 rpm Max. load kg 3,5 - Reduced.
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment 21 Sintéticos Drying programme for synthetic items Extra 22 Aclarados Rinses Long spin at maximum speed Max. load 7 kg With this programme it is possible to rinse and spin cotton garments which have been washed by hand. The machine performs 3 rinses, followed by a final long spin. The spin speed can be reduced.
Drying Programmes Degree of Drying Type of Fabric Max Load Spin Speed Suggested drying time in Mins Ideal for towelling materials Cotton and linen (bathrobes, bath towels, etc) 4 kg 3 kg 1,5 kg 1400 160-180 110-120 75-85 Suitable for items to put away without ironing Cotton and linen (bathrobes, bath towels, etc) 4 kg 3 kg 1,5 kg 1400 150-170 100-110 65-75 Suitable for items to put away without ironing Synthetics and mixed fabrics 2 kg 1 kg 900 90-100 55-65 Suitable for ironing Cotton a
Cleaning the drawer recess Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse programme without any clothes in the drum. Cleaning the pump The pump should be inspected regularly and particularly if: • the appliance does not empty and/or spin; • the appliance makes an unusual noise during draining due to objects such as safety pins, coins etc.
• Turn off the water tap. • Unscrew the hose from the tap. • Clean the filter in the hose with a stiff brush. • Screw the hose back onto the tap. Make sure the connection is tight. • Turn off the water tap. • Unscrew the inlet hose. • Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out. • Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again.
• : door open. Problem Once the problem has been eliminated, press the button 8 to restart the programme. If after all checks, the problem persists, contact your local Service Centre. Possible cause/Solution The door has not been closed. E40 • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown.
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain or inlet hose is damaged. • Replace it with a new one.
Problem Possible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in the drum, the machine will not spin.
Electrical connection Voltage - Overall power - Fuse Information on the electrical connection is given on the rating plate, on the inner edge of the appliance door.
2. Remove the power supply cable, the draining hose and inlet hose (if mounted) from the hose holders on the rear of the appliance. C B B C 5. 3. Unscrew and remove the central rear bolt A with the supplied spanner . Slide out the relevant plastic spacer. Remove the bracket D and tighten up the six smaller bolts C. D C 4. Unscrew and remove the two large rear bolts B and the six smaller bolts C. C www.zanussi.
6. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. Water inlet Warning! This appliance must be connected to a cold water supply. 1. Connect the water inlet hose supplied with the machine to a tap with a 3/4" thread. Always use the hose supplied with the appliance. Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc.
Important! Before connecting up the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. Water drainage The end of the drain hose can be positioned in three ways. • Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the machine is emptying.
A C 600 mm 16-22 mm min. 560 mm 596 mm B 555 mm C Ø 35 mm min. 820 mm 416 mm 176,5 mm 416 mm 75 mm 818 mm 60 mm 22±1,5 mm 14 mm 595-598 mm 170 mm 100 mm Preparation and assembly of the door The machine is originally prearranged for the assembly of a door opening from right to left. In this case it is sufficient to screw inthe hinges (1) and the counter-magnet (6) provided with the appliance, at the right level (Fig. B).
D E 6 4 6 1 7 4 5 3 2 If the door has to be opened from left to right, invert the position of the plates (7), the magnet (4) and the plate (5) (Fig. B and E). Mount the counter-magnet (6) and the hinges (1) as previously described. Electrical connection Information on the electrical connection is given on the rating plate on the inner edge of the appliance door. Check that your domestic electrical installation can take the maximum load required, also taking into account any other appliances in use.
• Measure out detergent according to the water hardness, the degree of soiling and the quantity of laundry being washed. 28 www.zanussi.
132828550-A-512011 www.zanussi.