User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. CHILDREN AND VULNERABLE PEOPLE SAFETY WARNING! Risk of suffocation, injury or permanent disability.
• • • • • • • • • • • • • • Connect the mains plug to the mains socket only at the end of the installation process. Make sure that the mains plug is accessible after installation.. The ventilation opening in the base (if applicable) must not be covered by a carpet, mat, or any floor covering. Ensure good air ventilation in the located room to avoid the back flow of gases into the room from appliances burning gas or other fuels, including open fires.
• • • • • • • Fabric softeners, or similar products, should only be used as specified by the product manufacturer’s instructions. Remove all objects from items that could be a source of fire ignition such as lighters or matches. Never stop the washer dryer before the end of the drying cycle unless all items are quickly removed and separated so that residual heat can dissipate.
• Ensure that there are no visible water leaks during and after the first use of the appliance. • USE WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • • • • • • • Plastic items are not heat resistant. – If a detergent ball is used, remove it before starting a drying programme. – Do not use a detergent ball if setting a nonstop programme. WARNING! Risk of injury or damage to the appliance. This appliance is for household use only.
• Turn the device clockwise, until the groove is horizontal. You cannot close the door. To close the door, turn the device anticlockwise until the groove is vertical.
DISPLAY A • B • • The display shows: A. Child lock indicator This device permits you to leave the appliance unattended during it's functioning (see «Child Lock» paragraph). The indicator comes when the related option is set. B. This area shows: • Programme time After the programme selection, the duration is displayed in hours and minutes (for example 2.10). The duration is calculated automatically on the basis of the maximum recommended load for each type of fabric.
Programme Temperature range 13 15 Delicates Maximum load Maximum spin speed 3 kg 700 rpm Delicate fabrics such as acrylics, viscose, polyester items. Normal soil. 3 kg 1200 rpm Items in denim and jersey. Also for dark coloured items. 2 kg 900 rpm Machine washable wool, hand washable wool and delicate fabrics with «hand washing» care symbol.2) 4 kg Drying programme for cotton items. 2 kg Drying programme for synthetic items. 7 kg 1400 rpm To rinse and spin the laundry.
Programme options compatibility Programme Spin Rinse Hold Quick Wash Eco Extra Rinse Easy Iron Cottons ■ ■ ■ ■ ■ ■ Cottons + Prewash ■ ■ ■ ■ ■ ■ Synthetics ■ ■ ■ ■ ■ ■ ■ ■ Delicates Jeans ■ ■ Handwash ■ ■ Rinses ■ ■ Drain ■ ■ ■ ■ ■ Spin PROGRAMMES FOR TIMED DRYING Dryness Level Type of fabric Extra Dry For towelling materials Cottons and Linen (bathrobes, bath towels, etc) Cupboard Dry1) For items to be stored Cottons and Linen (bathrobes, bath towels, etc)
CONSUMPTION VALUES The data in this table are approximate. Different variables can affect the data: the quantity and type of laundry, the water and ambient temperature. Programmes Load (kg) Energy conApproximate proWater consumption gramme duration (misumption (litre) (kWh) nutes) Cottons 60°C 7 1.35 67 150 Cottons Eco 60°C1) 7 1.05 57 219 Cottons 40°C 7 0.85 67 140 Synthetics 40°C 3 0.55 42 90 Delicates 40°C 3 0.55 63 65 Wool/Handwash 30°C 2 0.
For Cottons you can set a drying time from 10 minutes to 250 minutes (4.10), for synthetics from 10 minutes to 130 minutes (2.10). You cannot set all time values for different types of fabrics. EASY IRON The laundry is gently washed and spun to avoid any creasing. In this way ironing is easier. Furthermore, the appliance will perform some additional rinses in some programmes. On cotton programmes the maximum spin speed is reduced automatically.
• CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. DETERGENT COMPARTMENTS Detergent compartment for prewash phase. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). USING DETERGENT AND ADDITIVES 1. Measure out the detergent and the fabric conditioner. 2. Put the detergent and the fabric conditioner into the compartments. 3. Carefully close the detergent drawer.
INTERRUPTING A PROGRAMME AND CHANGING THE OPTIONS You can change only some options before they operate. 1. Press the button Start/Pause. The indicator flashes. 2. Change the options. 3. Press the button Start/Pause again. The programme continues. OPENING THE DOOR While a programme or the Delay Start operates, the appliance door is locked. The indicator Door is on. CAUTION! If the temperature and level of the water in the drum are too high and the drum still rotates, you cannot open the door.
3. Turn the programme knob to the position deactivate the appliance. to DAILY USE - DRYING ONLY WARNING! Refer to Safety chapters. DRYING SETTING The recommended load size is 3 kg for cottons and linen, and 2 kg for synthetic items. You can also to dry up to 4 kg of cotton items (see the «Drying Programme » table). WARNING! Open the water tap. Put the drain hose in the sink or connect to the drain pipe. 1. Load the laundry one item at a time. 2.
CAUTION! Do not use a dosing device/ball when carrying out a washing and drying programme. 1. Load the laundry one item at a time. 2. Put the detergent and the additives in the appropriate compartment. 3. Turn the programme knob to the required programme to switch the machine on. 4. Set the available options. To have a good drying performance do not exceed the maximum drying loads recommended in the user manual. Do not set a spin speed lower than the automatic speed of the set programme.
Special stain removers are available. Use the special stain remover that is applicable to the type of stain and fabric. • DETERGENTS AND ADDITIVES • Only use detergents and additives specially made for washing machines: – powder detergents for all types of fabric, – powder detergents for delicate fabrics (40 °C max) and woollens, – liquid detergents, preferably for low temperature wash programmes (60 °C max) for all types of fabric, or special for woollens only. • Do not mix different types of detergents.
2. Use special fabric conditioner for tumble dryers. When the drying programme is completed remove the laundry promptly. CARE AND CLEANING • WARNING! Refer to Safety chapters. • EXTERNAL CLEANING Clean the appliance with soap and warm water only. Fully dry all the surfaces. CAUTION! Do not use alcohol, solvents or chemical products. DESCALING If the water hardness in your area is high or moderate, we recommend that you use a water descaling product for washing machines.
A B • • • • • • 1 • 2 • • • Place a container close to the pump (A) to collect any spillage. Pull out the emergency emptying hose (B), place it in the container and remove its cap. When no more water comes out, unscrew the filter. Turn the filter anticlockwise. Remove the filter. Use pliers, if necessary. When removing the filter, always keep a rag nearby to dry up any water spillage. Clean the filter under a tap, to remove any traces of fluff.
FROST PRECAUTIONS If the appliance is installed in an area where the temperature can be less than 0° C, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket. 2. Close the water tap. 3. Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water flow out of the hoses. 4. Set the Drain programme and let it operate until the end of the cycle. 5.
POSSIBLE FAILURES Problem The programme does not start. Possible solution • • • • • • The appliance does not fill with water properly. • • • • • • • The appliance does not drain the water. • • • • • • The spin phase does not operate or the washing cycle lasts longer than usually. • • • There is water on the floor. • Make sure that the water tap is open. Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority.
Problem The washing results are not satisfactory. Possible solution • • • • Increase the detergent quantity or use a different detergent. Use special products to remove the stubborn stains before you wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load. You cannot set an option. • Make sure that you press only the wanted button(s). The machine does not dry or does not dry properly: • Make sure that you have set a suitable drying programme for your laundry.
• 2 • Remove the power supply cable and the draining hose from the hose holders on the rear of the appliance. • Unscrew the three bolts. • Slide out the relevant plastic spacers. • • 1 Level the appliance by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the appliance MUST be level and stable. If necessary, check the setting with a spirit level. Any necessary adjustment can be made with a spanner.
• • Connect the hose to a tap with a 3/4”thread. Always use the hose supplied with the appliance. The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. WATER DRAINAGE The end of the drain hose can be positioned in three ways: • Hooked over the edge of a sink using the plastic hose guide supplied with the machine.
600 mm 16-22 mm min. 596 mm 560 mm 555 mm X Ø 35 mm min. 820 mm 416 mm 818 mm 75 mm 22±1,5 mm 14 mm 60 mm 595-598 mm 170 mm 100 mm We recommend that you keep the packaging and the transit bolts for any movement of the appliance. PREPARATION AND ASSEMBLY OF THE DOOR The appliance is originally prearranged for the assembly of a door opening from right to left (see picture below) Hinges To mount the hinges drill two holes (dia. 35 mm, depth 12.
If the door has to be opened from left to right, invert the position of the plates E, the magnet D and the plate C. Mount the counter-magnet D and the hinges A as previously described. Do not remove the screw B! A D B A To align the door perfectly, loosen the screw, adjust the door and tighten the screw A again. The appliance is prearranged for a magnetic closure of the door. To enable a correct operation of this device, screw the counter-magnet A (steel disk + rubber ring) into the inner side of the door.
Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture IPX4 Water supply pressure Minimum Maximum 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) Maximum wash load Cotton 7 kg Maximum dry load Cotton Synthetics 4 kg 2 kg Spin Speed Maximum 1400 rpm ENVIRONMENTAL CONCERNS the symbol with the household waste.
132938301-A-282016 WWW.ZANUSSI.