User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • Old hose sets must not be reused. If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard. Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket. Do not use high pressure water sprays and/or steam to clean the appliance. Clean the appliance with a moist cloth. Use only neutral, detergents.
• • Do not put a container to collect possible water leakage under the appliance. Contact the Authorised Service Centre to ensure which accessories can be used. Do not touch the glass door while a programme is in operation. The glass can get hot. SERVICE • To repair the appliance contact an Authorised Service Centre. • Use original spare parts only. • • • • Disconnect the appliance from the mains electrical and water supplies. Cut off the mains electrical cable close to the appliance and dispose of it.
CONTROL PANEL CONTROL PANEL DESCRIPTION 1 2 3 4 Delay Start Special Cotton Jeans Normal Mini 30 + Prewash 90° 1200 60° 5 shirts Cotton Eco Synthetics Easy Iron 40° 900 30° 700 Mix 20° Spin Drain Delicates Rinse Wool/ Handwash Temperature 10 1 Programme knob 2 Display Spin Rinse Hold Quick Wash Extra Rinse 9 8 7 6 Start/Pause 5 7 Super quick button (Quick Wash) 3 Delay Start button (Delay Start) 4 Door locked indicator 5 Start/Pause button (Start/Pause) 8 Rinse Hold butto
PROGRAMMES PROGRAMME CHART Programme Temperature range Maximum load Maximum spin speed Programme description (Type of load and soil level) Washing programmes Cotton - Normal 90°C - Synthetics Delicates Rinse Cold 7 kg 1200 rpm White cotton and fast-coloured cotton. Normal soil. The energy consumption decreases and the time of the washing programme is extended. 3 kg 1200 rpm Synthetic items or mixed fabric items. Normal soil.
Programme Temperature range Easy Iron 60°C - Maximum load Maximum spin speed 1.5 kg 900 rpm Synthetic items requiring a gentle wash. Normal and light soil.4) 900 rpm Synthetic and mixed fabric items. Light soil items and items to freshen up. For 5 - 6 shirts. 3 kg 700 rpm Synthetic and delicate items. Light soil items or items to refresh. 7 kg 1200 rpm Items in denim and jersey. Also for dark coloured items.
■ ■ Mix 20° ■ ■ ■ Delicates Wool/Handwash ■ ■ Rinse ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ Delay Start Extra Rinse 2) Synthetics Quick Wash 1) Rinse Hold Spin Programme ■ ■ ■ Drain Spin ■ Easy Iron ■ 5 shirts ■ ■ ■ ■ ■ ■ ■ Mini 30 ■ Jeans ■ ■ ■ 1) If you set a shorter duration, we recommend that you decrease the load size. It is possible to fully load the appliance, however the washing results can be less satisfactory.
Programmes Load (kg) Energy consumption (kWh) Water consumption (litre) Approximate Remaining programme duration (mi- moisture (%)1) nutes) Cotton - Normal 40°C 7 1.0 61 186 53 Synthetics 40°C 3 0.65 58 125 35 Delicates 40°C 3 0.53 47 55 35 1.5 0.5 59 69 30 7 0.88 48 211 53 3.5 0.68 43 176 53 3.5 0.55 42 176 53 Wool/Handwash 30°C 2) Standard cotton programmes Standard 60°C cotton Standard 60°C cotton Standard 40°C cotton 1) At the end of spin phase.
QUICK WASH Press this button to decrease the programme duration. Set this option for items with light soil or items to refresh. EXTRA RINSE With this option you can add some rinses to a washing programme. Use this option for persons allergic to detergents and in areas where the water is soft. The related indicator comes on. DELAY START With this option you can delay the start of a programme from 30 minutes to 20 hours. The display shows the related indicator.
CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. LIQUID OR POWDER DETERGENT Pull out the detergent dispenser until it stops. The position A of the detergent divider is for powder detergent. To use liquid detergent: 1. Remove detergent divider from the position A. USING DETERGENT AND ADDITIVES 2 1 1. Measure out the detergent and the fabric conditioner. 2.
If you set something incorrect, the display shows the message STARTING A PROGRAMME WITHOUT THE DELAY START Press the button Start/Pause. • The indicator of the button Start/Pause stops to flash and stays on. • The programme starts, the door locks, the • Before starting the new programme the appliance could drain the water. In this case, make sure that the detergent is still in the detergent compartment, if not fill the detergent again. . indicator is on.
• • The drum turns regularly to prevent the creases in the laundry. The indicator Rinse Hold stays on to remind you to drain the water. is on. The indicator The door lock indicator of button Start/Pause flashes. The door stays locked. • You must drain the water to open the door. Draining the water: 1. To drain the water. • Set a Drain or a Spin programme. • Press the button Start/Pause. The appliance drains the water and spins. 2. When the programme is completed and the • door lock indicator the door.
• To use the correct quantity of detergent, check the water hardness of your domestic system. Refer to "Water hardness". WATER HARDNESS If the water hardness in your area is high or moderate, we recommend that you use a water softener for washing machines. In areas where the water hardness is soft it is not necessary to use a water softener. To know the water hardness in your area, contact your local water authority. Use the correct quantity of the water softener.
CLEANING THE DRAIN FILTER 1 2 3 4 5 6 7 8 1 2 9 1 0 2 1 CLEANING THE INLET HOSE AND THE VALVE FILTER 1 1 2 3 4 2 45° 3 20° EMERGENCY DRAIN Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (10) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1.
remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket. 2. Close the water tap. 3. Put the two ends of the inlet hose in a container and let the water flow out of the hose. 4. Empty the drain pump. Refer to the emergency drain procedure. 5. When the drain pump is empty, install the inlet hose again. WARNING! Make sure that the temperature is higher than 0 °C before you use the appliance again.
Problem The appliance does not drain the water. Possible solution • • • • • • The spin phase does not operate or the washing cycle lasts longer than usually. • • • There is water on the floor. • • • Make sure that the sink spigot is not clogged. Make sure that the drain hose has no kinks or bends. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Make sure that the connection of the drain hose is correct.
Electrical connection Voltage Overall power Fuse Frequency 230 V 2200 W 13 A 50 Hz Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture IPX4 Water supply pressure 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) Minimum Maximum Cold water Water supply 1) Maximum Load Cotton 7 kg Energy Efficiency Class Spin Speed A+++ Maximum 1200 rpm 1) Connect the water inlet hose to a water tap with
132255210-A-492015 WWW.ZANUSSI.