EN User manual Washing Machine ZWSE 7120 V
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ Environment concerns _ _ _ _ _ _ _ _ _ _ _ _ Product description _ _ _ _ _ _ _ _ _ _ _ _ _ Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Consumption values _ _ _ _ _ _ _ _ _ _ _ _ _ 2 3 4 5 5 6 7 Options _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Before first use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Hints and tips _ _
• Do not change the specification of this appliance. • Obey the maximum load volume of 5 kg (refer to the “Programme chart” chapter). • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet.
• This appliance complies with the E.E.C. Directives. Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage.
Product description 1 2 1 Worktop 2 Detergent dispenser 3 3 Control panel 4 Door handle 5 Drain pump filter 6 Rating plate 7 Feet for the appliance level 4 5 6 7 Control panel 1 2 3 4 Delay Start Special Cotton Jeans Mini 30 Normal 90° + Prewash 1200 60° 5 shirts Cotton Eco 40° 900 30° Synthetics Easy Iron 700 Mix 20° Spin Drain Delicates Rinse Wool/ Handwash Temperature 10 Spin Rinse Hold Quick Wash Extra Rinse 9 8 7 6 3 Delay start button (Delay Start) 4 Door locked
The symbol comes on the display when the related function is set. C) The programme time and the alarm codes. If the appliance has a malfunction, the display shows the alarm codes. Refer to the chapter 'Troubleshooting' . The display shows the message Err for some seconds if: – You set a function that is not applicable for the programme. – You change the programme while it operates.
Programme Temperature range Type of load and soil Maximum load, Maximum spin Easy Iron (Easy Iron) 60 °C (Cold) Synthetic fabric items. Normal soil. It prevents the laundry creases. 1 kg, 700 rpm 5 Shirts 30 °C Synthetic and mixed fabric items. Light soil and items to freshen up. For 5 - 6 shirts, 700 rpm Synthetic and delicate items. Light soil or items to freshen up. 2.5 kg, 700 rpm Mini 30 (Mini) 30 °C Items in denim and jersey. Also for items in dark colours.
Programmes Standard 40 °C cotton Load (Kg) Energy consumption (kWh) Water consumption (litre) Approximate programme duration (minutes) Remaining moisture (%)1) 2.5 0.50 33 147 53 1) At the end of spin phase. Off Mode (W) Left On Mode (W) 0.48 0.48 The information given in the charts above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC.
Rinse Hold button (Rinse Hold) Set this function to prevent the laundry creases. There is a water in the drum when the programme is completed. Super quick button (Quick Wash) Press this button to decrease the programme duration. Set this function for items with light soil or items to refresh. Extra rinse button (Extra Rinse) Press this button to add rinsing phases to a programme. Use this function for persons allergic to detergents and in areas where the water is soft.
Daily use 1. Open the water tap. 2. Connect the mains plug to the mains socket. 3. Put the laundry in the appliance. 4. Use the correct quantity of detergent and additives. 5. Set and start the correct programme for the type of laundry and soil. 2 1 Loading the laundry 1. 2. 3. Open the appliance door. Put the laundry in the drum, one item at a time. Shake the items before you put them in the appliance. Make sure not to put too much laundry in the drum. Close the door.
• Put it into the special guides in the middle of the compartment for the washing phase. • Measure out the detergent and the fabric conditioner. • Carefully close the detergent dispenser. – – – – When you use the detergent divider: Do not use gelatinous or thick liquid detergents. Do not put more liquid detergent than the edge of the detergent divider. Do not set the prewash phase. Do not set the delay start function, if it is available. Setting a programme 1.
To open the appliance door when the delay start operates: 1. Press the button Start/Pause to set the appliance to PAUSE. 2. Wait until the indicator goes off. 3. 4. You can open the door. Close the door and press the button Start/Pause again. The delay start continues to operate. To open the appliance door when the programme operates: 1. Turn the programme knob to to deactivate the appliance. 2. Wait for some minutes and then open the appliance door. 3. Close the appliance door. 4.
• Be careful with the curtains. Remove the hooks or put the curtains in a washing bag or pillowcase. • Do not wash in the appliance : – Laundry without hems or with cuts – Underwired bras. – Use a washing bag to wash small items. • A very small load can cause balance problems with the spin phase. If this occurs, adjust manually the items in the tub and start the spin phase again. Stubborn stains For some stains, water and detergent is not sufficient.
• Clean the drum with special product for stainless steel. • Start a short programme for cotton at the maximum temperature with a small quantity of detergent. Cleaning the inlet valve filter 1. 2. Door seal Regularly examine the seal and remove all objects from the inner part. 3. Cleaning the detergent dispenser 1. 2. 4. 3. 4. Cleaning the drain pump Warning! Do not clean the drain filter if the water in the appliance is hot. 1. 5. 14 2. 6. www.zanussi.
3. 4. 5. 6. 1 2 7. 8. 9. 10. 2 1 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'To clean the drain pump'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water.
• - The appliance door is open or not closed correctly. Problem The appliance does not start. Warning! Deactivate the appliance before you do the checks. Possible solution Make sure that the mains plug is connected in the mains socket. Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in the household fuse box. Make sure that the button Start/Pause has been pressed. If the delay start is set, cancel the setting or wait for the end of the countdown.
Problem You cannot open the appliance door. Possible solution Make sure that the washing programme is finished. Set the drain or the spin programme if there is water in the drum. The appliance makes an unusual noise. Make sure that the leveling of the appliance is correct. Refer to 'Installation instruction'. Make sure that the packaging and/or the transit bolts are removed. Refer to 'Installation instruction'. Add more laundry in the drum. The load may be too small.
Spin speed Maximum 1200 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 18 www.zanussi.
www.zanussi.
155248320-A-492013 www.zanussi.