EN User manual Washing Machine ZWN 8120 SE
Contents Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ 8 Consumption values _ _ _ _ _ _ _ _ _ _ _ _ 12 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ 13 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 14 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Technical data _ _ _ _ _ _
• All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. See relevant section in the user manual. • After having installed the appliance, check that it is not standing on the inlet and drain hose and the worktop is not pressing the electrical supply cable against the wall. • If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance.
Product description 1 2 3 4 5 6 1 Detergent dispenser drawer 2 Control panel 4 Rating Plate 5 Drain pump 3 Door opening handle 6 Adjustable feet Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash.
Control panel Below is a picture of the control panel. It shows the programme selector dial as well as the buttons and the pilot lights. These are presented by relevant numbers on the following pages. 1 2 3 4 5 6 7 8 9 1 Programme selector dial 2 TEMPERATURE button grammes the rinses will be performed with more water. 3 SPIN reduction button 4 EASY IRON button Rinse hold By selecting this function the water of the last rinse is not emptied out to prevent the fabrics from creasing.
up to a maximum of 20 hours by means of this button. Start Pause This button allows you to start or to interrupt the selected programme. Time Manager These buttons allows you to modify the programme duration automatically proposed by the appliance. • at the end of the cycle • if there is a fault. By pressing the 4 and 5 buttons simultaneously for about 6 seconds, the acoustic signal is deactivated (except if there is a fault). By pressing these 2 buttons again, the acoustic signal is reactivated.
empty out the water, please read the paragraph «At the end of the programme». 7.5: Option icons. • Extra Rinse , • Easy Iron , • Sensitive (if available). - not available in 7.6: Child safety lock this model 7.7: Soil degree icons • Intensive • Normal/Daily • Light/Quick • Super Quick 7.8: • Duration of the selected programme After selecting a programme, the duration is displayed in hours and minutes (for example ).
= Door locked = Time Manager Washing programmes Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options COTTON 90° (cold) Main wash - Rinses Maximum spin speed 1200 rpm Max. load 8 kg - Reduced load 4 kg1) White and coloured cotton (normally soiled items). SPIN REDUCTION NO SPIN RINSE HOLD EASY IRON EXTRA RINSE TIME MANAGER COTTON ECO2) 90° - 40° Main wash - Rinses Maximum spin speed 1200 rpm Max.
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment SYNTHETICS + PREWASH 60° (cold) Prewash - Main wash - Rinses Maximum spin speed 900 rpm Max. load 3.5 kg - Reduced load 2 kg1) Synthetic or mixed fabrics: underwear, coloured garments, non-shrink shirts, blouses, with prewash phase.
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options WOOL 40° (cold) Main wash - Rinses Maximum spin speed 1000 rpm Max. load 2 kg Washing programme for machine washable wool as well as for hand washable woollens and delicate fabrics. Note: A single or bulky item may cause imbalance. If the appliance doesn’t perform the final spin phase, add more items, redistribute the load manually and then select the spinning programme.
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options SOAK 30° Prewash - Soak for about 40 minutes - Stop with water in the tub Max. load 8 kg Special programme for heavily soiled laundry. The machine performs a soak at 30° C. At the end of this time the machine will stop automatically with water left in the tub.
Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Detergent Compartment Options DELICATE SPIN Drain and short spin Maximum spin speed 700 rpm Max. load 3.5 kg Separate short spin for delicate, synthetic, wool, silk and hand washed garments. = ON/OFF For cancelling the programme which is running or to switch the machine off .
Programmes1) Standard 40 °C cotton Load (kg) Energy consumption (kWh) Water consumption (litre) Approximate programme duration (minutes) Remaining moisture (%)2) 4 0.6 47 200 53 1) These values have been measured in the condition of CEI 60456. 2) At the end of spin phase. Helpful hints and tips Sorting out the laundry Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens.
Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone1), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Treat any residual marks with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Treat any residual marks with bleach.
turing residue from the drum and tub. Pour 1/2 a measure of detergent into the main wash compartment and start the machine. Daily use Load the laundry Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry.
Select the available option by pressing buttons 3, 4 and 5 Depending on the selected programme, different functions can be combined before pressing the button 8. By selecting an option the relevant pilot light illuminates. If an incorrect option is selected, the integrated red pilot light of the button 8 flashes 3 times and the Err message appears on the display for few seconds. For compatibility among the washing programmes and the options see chapter «Washing Programmes».
Type of washing cycle Soil level icon Super Quick 1) sition. Start the new programme by pressing the button 8 again. The washing water in the tub will be not emptied out. Type of fabric For items used or worn for a short time 1) We recommend you to reduce the load sizes (see Washing programmes table). Important! The Time Manager cannot be selected with the Economy (Eco) programmes. The availability of these soil level icons change according to the type of fabric as shown in the following chart.
2. Select the draining or spinning programme. 3. Reduce the spin speed if needed, by pressing the relevant button. 4. Press button 8. At the end of the programme, the door is released and can be opened. Turn the pro- gramme selector dial O to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells.
Open the pump door. Place a container close to the pump . Unscrew carefully the drain filter to drain out the water. When no more water comes out, remove the filter. If necessary, use pliers. Always keep a rag nearby to dry up any water spillage when removing the filter. Clean the filter under a tap, to remove any traces of fluff. Remove foreign bodies and fluff from the pump impeller. Replace the filter into the pump by inserting it correctly into the special guides. Screw firmly the filter.
• Unscrew the hose from the machine. Keep a rag nearby because some water may flow. • Clean the filter in the valve with a stiff brush or with the piece of cloth. 35° 45° • Screw the hose back to the machine and make sure the connection is tight. • Turn on the water tap. Frost precautions If the machine is installed in a place where the temperature could drop below 0°C, remove the remaining water from the inlet hose and the drain pump. 1. disconnect the mains plug from the mains socket. 2.
Once the problem has been eliminated, press the button 8 to restart the programme. If after Problem all checks, the problem persists, contact your local Service Centre. Possible cause/Solution The machine does not start: The door has not been closed. • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse.
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain or inlet hose is damaged. • Replace it with a new one.
Problem Possible cause/Solution The machine makes an unusual noise: The machine is fitted with a type of motor which makes an unusual noise compared with other traditional motors. This new motor ensures a softer start and more even distribution of the laundry in the drum when spinning, as well as increased stability of the machine. No water is visible in the drum: Machines based on modern technology operate very economically using very little water without affecting performance. Mod Prod . ... . No.
Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable. If necessary, check the setting with a spirit level. Remove the power supply cable and the hoses from the hose holders on the rear of the appliance. A Unscrew the three bolts A . Any necessary adjustment can be made with a spanner. B Slide out the relevant plastic spacers B .
Caution! Do not use the hose from your previous appliance to connect to water supply. Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. Water drainage The end of the drain hose can be positioned in three ways: Hooked over the edge of a sink using the plastic hose guide. In this case, make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall.
Caution! Should the appliance power supply cable need to be replaced, this must be carried out by a Service Centre. Environment concerns Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
www.zanussi.
148206230-A-262013 www.zanussi.