EN User manual Washing Machine ZWN 7140 L
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Control Panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ 12 Washing programmes _ _ _ _ _ _ _ _ _ _ _ Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ What to do if ...
• Obey the maximum load volume of 8 kg (refer to the “Programme chart” chapter). • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet.
This appliance complies with the E.E.C. Directives. Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage.
Product description 1 Detergent dispenser drawer 2 Control panel 1 2 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adjustable feet 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash.
Child safety Make sure that children or pets do not climb into the drum. To prevent children and pets becoming trapped inside the drum this machine incorporates a special feature. To activate this device, rotate the button (without pressing it) inside the door clockwise until the groove is horizontal. If necessary use a coin. To disable this device and restore the possibility of closing the door, rotate the button anti-clockwise until the groove is vertical.
Programme selector dial, spin speed button and available options Programme Selector Dial It allows you to switch the appliance on/off and/or to select a programme. Spin Reduction By pressing this button you can change the spin speed of the selected programme. Available options: Rinse hold By selecting this function the water of the last rinse is not emptied out to prevent the fabrics from creasing. Before opening the door it will be necessary to empty out the water.
10.2: • Duration of the selected programme After selecting a programme, the duration is displayed in hours and minutes (for example ). The duration is calculated automatically on the basis of the maximum recommended load for each type of fabric. After the programme has started, the time remaining is updated every minute. • Delayed start The Selected delay set by pressing the relevant button appears on the display for a few seconds, then the duration of the selected programme is displayed again.
Daily use Load the laundry Flap for powder or liquid detergent Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry.
MAX • Measure out the detergent. • Pour the powder detergent into the main wash com. partment • Remove the remaining powder form the flap. • There is remaining powder detergent in the main wash compartment at the end of a washing programme. Check if the flap is in the right position. The flap is up and you wish to use liquid detergent: • Turn the flap down. • Measure out the detergent.
For the compatibility among the washing programmes and the options see chapter «Washing programmes». Start the programme by pressing button 7 To start the selected programme, press this button; the corresponding green pilot light stops blinking. The pilot light 9 illuminates to indicate that the appliance starts operating and the door is locked. If you have chosen a delayed start, the machine will begin the countdown.
level is too high. In any case, do not try to force the door open! If you cannot open the door but you need to open it, you have to switch the machine off by . After a few miturning the selector dial to nutes the door can be opened. (Pay attention to the water level and temperature!). After closing the door, it is necessary to select the programme and options again and to press button 7. At the end of the programme The machine stops automatically.
Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone1), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Treat any residual marks with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Treat any residual marks with bleach.
Washing programmes Programme Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Detergent Compartment Cottons1) 90° - Cold Main wash - Rinses Maximum spin speed at 1400 rpm Max. load 8 kg - Reduced load 4 kg White and coloured cotton (normally soiled items). SPIN REDUCTION RINSE HOLD ECO2) SUPER QUICK3) PREWASH EASY IRON EXTRA RINSE 4) Synthetics 60° - Cold Main wash - Rinses Maximum spin speed at 900 rpm Max. load 3.
Programme Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Mix 20° 20° Main wash - Rinses Maximum spin speed at 900 rpm Max. load 3 kg Highly energy efficient cold wash programme for lightly soiled laundry. This programme requires a detergent which is active in cold water. Options Detergent Compartment SPIN REDUCTION RINSE HOLD EXTRA RINSE Soak 30° Prewash - Soak for about 40 minutes - Stop with water in the tub Max.
Programme Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Spin Drain and long spin Maximum spin speed at 1400 rpm Max. load 8 kg Separate spin for hand washed garments and after programmes with the option selected, which ends with water left in the tub . You can choose the spin speed by pressing the relevant button to adapt it to the fabrics to be spun.
AX M MA X Remove the drawer by pressing the catch downwards and by pulling it out. Flush it out under a tap, to remove any traces of accumulated powder. To aid cleaning, the top part of the additive compartment should be removed. Open the pump door. Place a container close to the pump to collect any spillage. Pull out the emergency emptying hose, place it in the container and remove its cap.
Replace the filter into the pump by inserting it correctly into the special guides. Screw the pump cover firmly by turning it clockwise. Close the pump door. Caution! When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty.
• if necessary, wait until the water has cooled down; • open the pump door; • place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Empty the bowl.
Problem Possible cause/Solution The machine does not fill: The water tap is closed. • Open the water tap. The inlet hose is squashed or kinked. • Check the inlet hose connection. The filter in the inlet hose or the inlet valve filter are blocked. • Clean the water inlet filters. (See "Cleaning the water inlet filters" for more details). The door is not properly closed. • Close the door firmly. The machine does not empty and/or does not spin: The drain hose is squashed or kinked.
Problem Possible cause/Solution The machine vibrates is noisy: The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The support feet have not been adjusted • Check the correct levelling of the appliance. The laundry is not evenly distributed in the drum. • Redistribute the laundry. Maybe there is very little laundry in the drum. • Load more laundry.
Maximum Load Cotton 8 kg1) Spin Speed Maximum 1400 rpm 1) Maximum load in accordance with EN60456. Consumption values The data of this table are approximate. Different causes can change the data: the quantity and type of laundry, the water and ambient temperature. Programmes Load (kg) Energy consumption (kWh) Water consumption (litre) Approximate programme duration (minutes) Remaining moisture (%)1) Cottons 60 °C 8 1.4 63 160 52 Cottons 40 °C 8 0.
You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. After removing all the packaging, carefully lay machine on it's back to remove the polystyrene base from the bottom. Unscrew the three bolts. Open the porthole, remove the polystyrene block fitted on the door seal and pull out all items from the drum. Remove the power supply cable and the hose from the hose holders on the rear of the appliance.
Caution! Do not use the hose from your previous appliance to connect to water supply. 1. 35° 2. Connect the appropriate end of the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. Water drainage This appliance is designed to be permanently plumbed into your home's drainage system using one of the following methods. 1. Into a drainage standpipe. Firstly form a hook in the end of the drain hose using the “U” piece” supplied.
If you intend to drain the hose from the machine into a sink, make sure that the sink is empty and the plug hole is not blocked. Use the plastic “U - Piece” supplied. Min. 60 cm (23.6”) Max. 90 cm (35.4”) If your drain hose looks like this (see beside) you do not require the “U” piece”. Just push the hose firmly in to the standpipe.
>PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers. Ecological hints To save water, energy and to help protect the environment, we recommend that you follow these tips: • Normally soiled laundry may be washed without prewashing in order to save deter- 26 gent, water and time (the environment is protected too!). • The machine works more economically if it is fully loaded.
www.zanussi.
192984252-A-262013 www.zanussi.
