EN User manual Washing machine ZWN 7125 2
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Washing Programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 12 Daily Use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 12 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ What to do if ...
• If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. • Always be sure, that there is no water leakage from hoses and their connections after the installation. • If the appliance is installed in a location subject to frost, please read the “dangers of freezing” chapter. • Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person.
Product description 1 2 3 4 5 6 Detergent dispenser drawer Control panel Door opening handle Rating plate Drain pump Adjustable feet 1 2 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash.
10 9 1 2 1 Programme selector dial 2 SPIN reduction button (Centrifugado) 3 OPTION button (Opciones): – Economy (Eco) – Super Quick (Super rápido) 4 PREWASH button (Prelavado) 3 4 5 6 7 8 9 10 5 6 7 8 EASY IRON button (Plancha fácil) EXTRA RINSE button (AquaCare) START/PAUSE button (Start/Pausa) DELAY START button (Inicio diferido) DOOR LOCKED pilot light (Puerta) Display Table of symbols = Rinse hold = Child Safety Lock Programme selector dial, spin speed button and available options Progr
Easy Iron By selecting this option the laundry is gently washed and spun to avoid any creasing. In this way ironing is easier. Furthermore the machine will perform some additional rinses in some programmes. On cotton programmes the maximum spin speed is reduced automatically. Extra Rinse This appliance is designed to save energy. If it necessary to rinse the laundry using an extra quantity of water (extra rinse), select this option. Some additional rinses will be performed.
Washing Programmes Programme Maximum and Minimum Temperature - Cycle Description Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Algodón COTTONS 90° - Cold1) Main wash - Rinses Maximum spin speed at 1200 rpm Max. load 8 kg - Reduced load 4 kg 2) White and coloured cotton (normally soiled items). SPIN REDUCTION RINSE HOLD ECONOMY3) SUPER QUICK PREWASH4) EASY IRON EXTRA RINSE Sintéticos SYNTHETICS 60° - Cold Main wash - Rinses Maximum spin speed at 900 rpm Max.
Programme Maximum and Minimum Temperature - Cycle Description Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Lana WOOL 40° Main wash - Rinses Maximum spin speed at 900 rpm Max. load 2 kg Washing programme for machine washable wool as well as for hand washable woollens and delicate fabrics. Note : A single or bulky item may cause imbalance. If the appliance doesn’t perform the final spin phase, add more items, redistribute the load manually and then select the spinning programme.
Programme Maximum and Minimum Temperature - Cycle Description Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Detergent Compartment Remojo SOAK 30° Prewash - Soak for about 40 minutes - Stop with water in the tub Max. load 8 kg Special programme for heavily soiled laundry. The machine performs a soak at 30°C. At the end of this time the machine will stop automatically with water left in the tub.
Programme Maximum and Minimum Temperature - Cycle Description Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Centrifugado SPIN Drain and long spin Maximum spin speed at 1200 rpm Max. load 8 kg Separate spin for hand washed garments and after programmes with the option selected, which ends with water left in the tub . You can choose the spin speed by pressing the relevant button to adapt it to the fabrics to be spun.
Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone1), lay the garment on a soft cloth and dab the stain. Lipstick: moisten with acetone as above, then treat stains with methylated spirits. Treat any residual marks with bleach. Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Treat any residual marks with bleach.
Personalisation Acoustic signals The machine is provided with an acoustic device, which sounds in the following cases: • at the end of the cycle • if there is a fault. By pressing the 4 and 5 buttons simultaneously for about 6 seconds , the acoustic signal is deactivated (except if there is a fault). By pressing these 2 buttons again, the acoustic signal is reactivated.
When these buttons are pressed, the corresponding pilot lights illuminate. When they are pressed again, the pilot lights go out. If an incorrect option is selected, the integrated red pilot light of the button 7 flashes 3 times and the message Err is displayed. For the compatibility among the washing programmes and the options see chapter «Washing programmes» . Start the programme by pressing button 7 To start the selected programme, press this button; the corresponding green pilot light stops blinking.
1. Turn the programme selector dial to . 2. Select the draining or spinning programme. 3. Reduce the spin speed if needed, by pressing the relevant button. 4. Press button 7 . At the end of the programme, the door is released and can to be opened. Turn the programme selector dial to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap.
• the appliance makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump; • a problem with water draining is detected (see chapter “What to do if...” for more details). Warning! Before opening the pump door, switch the appliance off and remove the mains plug from the socket. Proceed as follows: • Unplug the appliance. • If it is necessary, wait until the water has cooled down. Open the pump door. Place a container close to the pump to collect any spillage.
• Turn off the water tap. • Unscrew the hose from the tap. • Clean the filter in the hose with a stiff brush. • Screw the hose back onto the tap. Make sure the connection is tight. • Turn off the water tap. • Unscrew the inlet hose. • Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out. • Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again.
Once the problem has been eliminated, press the button 7 to restart the programme. If after all checks, the problem persists, contact your local Service Centre. Problem Possible cause/Solution The machine does not start: The door has not been closed. • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse.
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain or inlet hose is damaged. • Replace it with a new one.
Problem Possible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in the drum, the machine will not spin.
Consumption values Programme Energy consumption (KWh) Water consumption (litres) White Cottons 90° 2,6 69 Cottons 60° 1,6 65 Cotton Energy Saving Programme 60° 1) 1,36 59 Cottons 40° 0,95 65 Synthetics 40° 0,6 55 Delicates 40° 0,7 69 Wool/ Handwash 30° 0,35 58 Programme duration (Minutes) For the duration of the programmes, please refer to the display on the control panel.
Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable. Any necessary adjustment can be made with a spanner.
In a sink drain pipe branch . This branch must be above the trap so that the bend is at least 60 cm above the ground. Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm. The end of the drain hose must always be ventilated , i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose. The drain hose must not be kinked.
www.zanussi.