EN User manual Washing Machine ZWN 7100 L ZWN 7120 L
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ 12 Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ What to
• Obey the maximum load volume of 8 kg (refer to the “Programme chart” chapter). • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet.
• Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. Use Warning! Risk of injury, electrical shock, fire, burns or damage to the appliance. • Use this appliance in a household environment. • Obey the safety instructions on the detergent packaging. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance.
Product description 1 Detergent dispenser drawer 2 Control panel 1 2 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adjustable feet 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash.
Child safety Make sure that children or pets do not climb into the drum. To prevent children and pets becoming trapped inside the drum this machine incorporates a special feature. To activate this device, rotate the button (without pressing it) inside the door clockwise until the groove is horizontal. If necessary use a coin. To disable this device and restore the possibility of closing the door, rotate the button anti-clockwise until the groove is vertical.
Rinse Hold Easy Iron Options Extra Rinse Super Quick Start/Pause Economy Door locked Child lock Delay Start Programme selector dial, spin speed button and available options Programme Selector Dial It allows you to switch the appliance on/off and/ or to select a programme. Spin Reduction By pressing this button you can change the spin speed of the selected programme.
Display (10) 10.1 10.2 The display shows the following information: 10.1: Child safety lock This device permits you to leave the appliance unattended during it's functioning. 10.2: • Duration of the selected programme After selecting a programme, the duration is displayed in hours and minutes (for example ). The duration is calculated automatically on the basis of the maximum recommended load for each type of fabric. After the programme has started, the time remaining is updated every minute.
To enable or disable this option press simultaneously for about 6 seconds buttons 2 and 3 until on the display, the icon appears. appears or dis- Daily use Load the laundry Flap for powder or liquid detergent Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry.
• Measure out the detergent. • Pour the powder detergent into the main wash com. partment • Remove the remaining powder form the flap. • There is remaining powder detergent in the main wash compartment at the end of a washing programme. Check if the flap is in the right position. The flap is up and you wish to use liquid detergent: • Turn the flap down. • Measure out the detergent.
Start the programme by pressing button 7 To start the selected programme, press this button; the corresponding green pilot light stops blinking. The pilot light 9 illuminates to indicate that the appliance starts operating and the door is locked. If you have chosen a delayed start, the machine will begin the countdown. Important! If an incorrect option is selected, the message Err is displayed for a few seconds and the red pilot light of this button blinks 3 times.
After closing the door, it is necessary to select the programme and options again and to press button 7. At the end of the programme The machine stops automatically. Some acoustic signals sound and a blinking appears on the display. The pilot light of button 7 and the pilot light 9 go off. If you have set a programme or an option that ends with water left in the tub, the pilot light 9 remains on. The door is locked to indicate that the water must be emptied out.
Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Treat any residual marks with bleach. Ink: depending on the type of ink, moisten the fabric first with acetone1), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste.
Programme Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Detergent Compartment SPIN REDUCTION RINSE HOLD ECO2) SUPER QUICK3) PREWASH EASY IRON EXTRA RINSE 4) DELICATES 40° (Cold) Main wash - Rinses Maximum spin speed at 700 rpm Max. load kg 3,5 - Reduced load kg 1,5 Delicate fabrics: acrylics, viscose, polyester.
Programme Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Detergent Compartment SOAK 30° Prewash - Soak for about 40 minutes - Stop with water in the tub Max. load 8 kg Special programme for heavily soiled laundry. The machine performs a soak at 30°C. At the end of this time the machine will stop automatically with water left in the tub.
Programme Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Detergent Compartment = OFF For cancelling the programme which is running or to switch the machine off .
Replace the drawer and run the rinse programme without any clothes in the drum. Cleaning the pump The pump should be inspected regularly and particularly if: • the appliance does not empty and/or spin; • the appliance makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump; • a problem with water draining is detected (see chapter “What to do if...” for more details).
Cleaning the water inlet filters Important! If the appliance doesn't fill, takes long to fill with water, the starting button blinks yellow or the display (if available) shows the relevant alarm (see chapter "What to do if..." for more details), check if the water inlet filters are blocked . To clean the water inlet filters: • Turn off the water tap. • Unscrew the hose from the tap. • Clean the filter in the hose with a stiff brush. • Screw the hose back onto the tap. Make sure the connection is tight.
Important! Every time you drain the water through the emergency emptying hose you must pour 2 litres of water into the main wash compartment of the detergent drawer and then run the drain programme. This will activate the ECO Valve device avoiding that part of the detergent remains unused at next washing. What to do if ... Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer.
Problem Possible cause/Solution The machine does not empty and/or does not spin: The drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged. • Clean the drain filter. An option or a programme that ends with the water still in the tub or a that eliminates all the spinning phases has been selected. • Select the draining or spinning programme. The laundry is not evenly distributed in the drum. • Redistribute the laundry.
Problem Possible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in the drum, the machine will not spin.
Programmes Load (kg) Energy consumption (kWh) Water consumption (litre) Approximate programme duration (minutes) Remaining moisture (%)1) ZWN7100L Remaining moisture (%)1) ZWN7120L Cottons 60 °C 8 1.4 63 160 60 53 Cottons 40 °C 8 0.6 63 130 60 53 Synthetics 40 °C 3,5 0.6 54 80 37 35 Delicates 40 °C 3 0.6 63 65 37 35 Wool/Hand wash 30 °C 2 0.25 55 60 32 30 Standard cotton programmes Standard 60 °C cotton 8 1.17 61 205 60 53 Standard 60 °C cotton 4 0.
If necessary, check the setting with a spirit level. Unscrew the three bolts. Slide out the relevant plastic spacers. Open the porthole, remove the polystyrene block fitted on the door seal and pull out all items from the drum. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. Positioning Install the machine on a flat hard floor.
In this case, make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. 35° 45° The other end of the inlet hose which connects to the appliance can be turned as showed in the picture. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut.
Packaging materials The materials marked with the symbol are recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers. Ecological hints To save water, energy and to help protect the environment, we recommend that you follow these tips: www.zanussi.com • Normally soiled laundry may be washed without prewashing in order to save detergent, water and time (the environment is protected too!).
www.zanussi.
www.zanussi.
192986482-A-512012 www.zanussi.